Langenbach A, Oppel Pascal, Grupp Sina, Krinner Sebastian, Pachowsky Milena, Buder Thomas, Schulz-Drost Melanie, Hennig Friedrich F, Schulz-Drost Stefan
Department of Trauma and Orthopedic Surgery, University Hospital Erlangen, Krankenhausstr. 12, 91054, Erlangen, Germany.
Institute of Anatomy I, University of Erlangen, Krankenhausstr. 9, 91054, Erlangen, Germany.
Eur J Trauma Emerg Surg. 2018 Jun;44(3):471-481. doi: 10.1007/s00068-017-0877-4. Epub 2017 Nov 9.
Stabilizing techniques for flail chest injuries are described through wide surgical approaches to the chest wall, especially in the most affected posterior and lateral regions. Severe morbidity due to these invasive approaches needs to be considered due to dissection of the scapular guiding muscles and the risk of injuries to neurovascular bundles. This study discusses possibilities for minimized approaches to the posterior and lateral regions.
Ten fresh-frozen cadavers in lateral decubitus position were observed on both sides. Each surgical arm was kept mobile during the procedure. Approaches were performed following a standard protocol with muscle-sparing incisions starting with 5 cm in length and extending to 10 and 15 cm. The accessible surface comparing the extensions was measured. Visible ribs were counted. In a next step, MatrixRib Plates were fixed to those ribs to prove the feasibility of rib stabilization through limited approaches.
Combinations of the posterior and lateral minimized approaches allow surgical fixation of 6-9 and 7-11 ribs through 5 and 10 cm incisions, respectively. In the case of an extreme expansion of a rib fracture series, an access extension can be made to 15 cm to be able to adequately supply the entire hemithorax using two approaches.
Extensive invasive surgical approaches to the thoracic wall can be replaced by reduced invasive and muscle-sparing access combinations. A free-moving positioning of the arm and an accurate preoperative plan for minimizing approaches are essential. Minimally invasive plate techniques are very helpful adjuncts.
通过广泛的胸壁手术入路描述连枷胸损伤的稳定技术,尤其是在受影响最严重的后侧和外侧区域。由于肩胛引导肌的解剖以及神经血管束损伤的风险,需要考虑这些侵入性入路导致的严重并发症。本研究讨论了减少后侧和外侧区域入路的可能性。
观察10例处于侧卧位的新鲜冷冻尸体的双侧。在手术过程中每个手术侧手臂保持可活动状态。按照标准方案进行手术入路,采用保留肌肉的切口,起始长度为5厘米,延伸至10厘米和15厘米。测量比较不同延伸长度时可触及的表面面积。计数可见肋骨。下一步,将MatrixRib钢板固定于这些肋骨上,以证明通过有限入路进行肋骨稳定固定的可行性。
后侧和外侧最小化入路的组合分别允许通过5厘米和10厘米的切口对6 - 9根和7 - 11根肋骨进行手术固定。在肋骨骨折系列极度扩展的情况下,入路可延长至15厘米,以便能够通过两种入路充分处理整个半侧胸廓。
广泛的胸壁侵入性手术入路可被减少侵入性和保留肌肉的入路组合所取代。手臂的自由活动定位以及精确的术前最小化入路计划至关重要。微创钢板技术是非常有用的辅助手段。