Badran Ismail, Shi Yujun
Department of Chemistry, University of Calgary, Calgary, Alberta T2N 1N4, Canada.
Phys Chem Chem Phys. 2017 Dec 20;20(1):75-85. doi: 10.1039/c7cp06082c.
The reaction kinetics of the decomposition of 1-methylsilacyclobutane (MSCB) in a hot wire chemical vapor deposition (HWCVD) reactor was investigated. The stable reaction products were monitored using vacuum ultraviolet laser single photon ionization in tandem with time-of-flight mass spectrometry. Steady-state approximation was used to determine the rate constants of three individual decomposition pathways of MSCB, i.e., cycloreversion to form ethene and methylsilene (R1), ring opening to form propene and methylsilylene (R2), and exocyclic Si-CH bond cleavage to form ˙CH radicals (R3). The activation energies (E) for R2 and R3 in a HWCVD reactor were determined to be 86.6 kJ mol and 106 kJ mol, respectively. The fact that these E values are close to those obtained for the MSCB decomposition on metal surfaces under collision-free conditions indicates that the heterogeneous reactions on the hot wire surface govern the gas-phase reaction kinetics in the HWCVD reactor. In addition, the E values obtained from a theoretical study of the decomposition kinetics using ab initio calculations at the CCSD(T)/6-311++G(3d,2p)//MP2/6-311++G(d,p) level were 62.9 kcal mol (i.e., 263 kJ mol), 62.0 kcal mol (i.e., 259 kJ mol), and 86.2 kcal mol (i.e., 361 kJ mol) for R1, R2, and R3, respectively. The much lower experimental E values compared with those from the theoretical calculations clearly suggest that the tungsten filament in the HWCVD reactor catalyzed the decomposition.
研究了1-甲基硅环丁烷(MSCB)在热丝化学气相沉积(HWCVD)反应器中的分解反应动力学。使用真空紫外激光单光子电离与飞行时间质谱联用监测稳定的反应产物。采用稳态近似法确定了MSCB三种单独分解途径的速率常数,即环化转化形成乙烯和甲基硅烯(R1)、开环形成丙烯和甲基甲硅烯(R2)以及环外Si-CH键断裂形成˙CH自由基(R3)。在HWCVD反应器中,R2和R3的活化能(E)分别确定为86.6 kJ/mol和106 kJ/mol。这些E值与在无碰撞条件下金属表面上MSCB分解所获得的值接近,这一事实表明热丝表面上的多相反应控制了HWCVD反应器中的气相反应动力学。此外,在CCSD(T)/6-311++G(3d,2p)//MP2/6-311++G(d,p)水平上使用从头算计算对分解动力学进行理论研究得到的R1、R2和R3的E值分别为62.9 kcal/mol(即263 kJ/mol)、62.0 kcal/mol(即259 kJ/mol)和86.2 kcal/mol(即361 kJ/mol)。与理论计算值相比,实验得到的E值要低得多,这清楚地表明HWCVD反应器中的钨丝催化了分解反应。