Roscioli Joseph R, Herndon Scott C, Yacovitch Tara I, Knighton W Berk, Zavala-Araiza Daniel, Johnson Matthew R, Tyner David R
a Aerodyne Research Inc ., Billerica , MA , USA.
b Department of Chemistry and Biochemistry , Montana State University , Bozeman , MT , USA.
J Air Waste Manag Assoc. 2018 Jul;68(7):671-684. doi: 10.1080/10962247.2018.1436096. Epub 2018 May 8.
Cold heavy oil production with sands (CHOPS) is a common oil extraction method in the Canadian provinces of Alberta and Saskatchewan that can result in significant methane emissions due to annular venting. Little is known about the magnitude of these emissions, nor their contributions to the regional methane budget. Here the authors present the results of field measurements of methane emissions from CHOPS wells and compare them with self-reported venting rates. The tracer ratio method was used not only to analyze total site emissions but at one site it was also used to locate primary emission sources and quantify their contributions to the facility-wide emission rate, revealing the annular vent to be a dominant source. Emissions measured from five different CHOPS sites in Alberta showed large discrepancies between the measured and reported rates, with emissions being mainly underreported. These methane emission rates are placed in the context of current reporting procedures and the role that gas-oil ratio (GOR) measurements play in vented volume estimates. In addition to methane, emissions of higher hydrocarbons were also measured; a chemical "fingerprint" associated with CHOPS wells in this region reveals very low emission ratios of ethane, propane, and aromatics versus methane. The results of this study may inform future studies of CHOPS sites and aid in developing policy to mitigate regional methane emissions.
Methane measurements from cold heavy oil production with sand (CHOPS) sites identify annular venting to be a potentially major source of emissions at these facilities. The measured emission rates are generally larger than reported by operators, with uncertainty in the gas-oil ratio (GOR) possibly playing a large role in this discrepancy. These results have potential policy implications for reducing methane emissions in Alberta in order to achieve the Canadian government's goal of reducing methane emissions by 40-45% below 2012 levels within 8 yr.
含砂冷采重油(CHOPS)是加拿大艾伯塔省和萨斯喀彻温省常用的石油开采方法,由于环形放空,该方法会导致大量甲烷排放。目前对于这些排放的规模及其对区域甲烷预算的贡献了解甚少。在此,作者展示了来自CHOPS油井甲烷排放的现场测量结果,并将其与自行报告的放空速率进行比较。示踪剂比率法不仅用于分析场地总排放量,还在一个场地用于定位主要排放源并量化其对设施总排放率的贡献,结果表明环形放空是主要排放源。在艾伯塔省五个不同的CHOPS场地测量的排放量显示,测量值与报告值之间存在很大差异,排放量大多被少报。这些甲烷排放速率是在当前报告程序以及气油比(GOR)测量在放空量估算中所起作用的背景下得出的。除甲烷外,还测量了更高碳氢化合物的排放;该地区与CHOPS油井相关的化学“指纹”显示,乙烷、丙烷和芳烃相对于甲烷的排放比率非常低。本研究结果可为未来CHOPS场地的研究提供参考,并有助于制定减少区域甲烷排放的政策。
对含砂冷采重油(CHOPS)场地的甲烷测量表明,环形放空可能是这些设施的主要排放源。测量的排放速率通常大于运营商报告的速率,气油比(GOR)的不确定性可能在这种差异中起很大作用。这些结果对于艾伯塔省减少甲烷排放具有潜在的政策意义,以实现加拿大政府在8年内将甲烷排放量比2012年水平降低40 - 45%的目标。