Analyte-triggered cyclic autocatalytic oxidation amplification combined with an upconversion nanoparticle probe for fluorometric detection of copper(II).

The authors describe an upconversion nanoparticle-based (UCNP-based) fluorometric method for ultrasensitive and selective detection of Cu. The UCNPs show a strong emission band at 550 nm under near-infrared excitation at 980 nm. The principle of the strategy is that gold nanoparticles (AuNP) can quench the fluorescence of UCNP. In contrast, the addition of L-cysteine (Cys) can induce the aggregation of AuNP, resulting in a fluorescence recovery of the UCNPs. On addition of Cu, it oxidizes Cys to cystine and is reduced to Cu. The Cu thusformed can be oxidized cyclically to Cu by dissolved O, which catalyzes and recycles the whole reaction. Thus, the aggregation of AuNP is inhibited and the fluorescence recovered by Cys is quenched. Under the optimal condition, the quenching efficiency shows a good linear response to the concentrations of Cu in the 0.4-40 nM range. The limit of detection is 0.16 nM, which is 5 orders of magnitude lower than the U.S. Environmental Protection Agency limit for Cu in drinking water (20 μM). The method has been further applied to monitor Cu levels in real samples. The results of detection are well consistent with those obtained by atomic absorption spectroscopy. Graphical abstract Gold nanoparticles (AuNP) as a high efficient fluorescence quenching reagent of upconversion nanoparticles (UCNP) were used in a fluorometric method for detection of Cu based on a cyclic catalytic oxidation amplification strategy.