Department of Chemistry , Emory University , 201 Dowman Drive , Atlanta , Georgia 30322 , United States.
Langmuir. 2018 Oct 30;34(43):12947-12956. doi: 10.1021/acs.langmuir.8b02633. Epub 2018 Oct 17.
Computational studies have been carried out to investigate the equilibrium partitioning of size-mismatched impurities between the bulk solid and grain boundary (GB) environments in 2d hard-sphere monolayers. The solvent repacking Monte Carlo method and a new variation were used to exchange varying numbers and types of particles under conditions of fixed particle fugacities, allowing efficient sampling of impurity particle distributions even within the bulk solid. Measurements of GB stiffness depression arising from the impurities were made via the capillary fluctuation method and found to agree with calculations based on the Gibbs adsorption isotherm, providing a test of the internal consistency of the results. The dependence of the excess concentration at the GB on factors, including impurity size (diameter ratios λ = 0.5-4 times the majority host particle diameter), impurity concentration, grain misorientation angle, and packing pressure, was studied. In general, the affinity of impurity particles for GB increased with the difference between their size and the host particles, and varied with grain misorientation angle with a dependence reflecting the excess free area at the GB. Impurities with λ = 4 were exceptions to both these trends, due to their ability to substitute efficiently for six-coordinate host particles within the bulk and for five-coordinate host particles at dislocations in the grain boundaries. Comparison with results from an experimental study of mixed colloidal monolayers raises questions about how kinetic effects during grain coarsening might produce less impurity segregation to the GB than equilibrium exchange.
已经进行了计算研究,以研究尺寸不匹配的杂质在二维硬球单层体相和晶界 (GB) 环境之间的平衡分配。溶剂重排蒙特卡罗方法和一种新的变体被用来在固定粒子逸度的条件下交换不同数量和类型的粒子,从而即使在体相内部也能够有效地对杂质粒子分布进行采样。通过毛细波动法测量了由于杂质引起的 GB 硬度降低,并发现与基于吉布斯吸附等温线的计算相符,这为结果的内部一致性提供了检验。研究了 GB 处过剩浓度对各种因素的依赖性,包括杂质尺寸(直径比λ= 0.5-4 倍于多数主体粒子直径)、杂质浓度、晶粒取向角和堆积压力。一般来说,杂质粒子与 GB 的亲和力随其尺寸与主体粒子的差异而增加,并随晶粒取向角而变化,其依赖性反映了 GB 处的过剩自由面积。直径比λ=4 的杂质是这两种趋势的例外,这是因为它们能够在体相内有效地替代六配位主体粒子,以及在晶粒边界处的五配位主体粒子。与混合胶体单层的实验研究结果进行比较,引发了关于在晶粒粗化过程中的动力学效应如何可能导致杂质向 GB 的偏析少于平衡交换的问题。