Department of Radiation Sciences, Diagnostic Radiology, Umea University, Umea, Sweden.
PLoS One. 2018 Dec 13;13(12):e0209169. doi: 10.1371/journal.pone.0209169. eCollection 2018.
11C-acetate (ACE)-PET/CT is used for staging of high-risk prostate cancer. PET data is reconstructed with iterative algorithms, such as VUEPointHD ViP (VPHD) and VUEPoint HD Sharp IR (SharpIR), the latter with additional resolution recovery. It is expected that the resolution recovery algorithm should render more accurate maximum and mean standardized uptake values (SUVmax and SUVmean) and functional tumor volumes (FTV) than the ordinary OSEM. Performing quantitative analysis, choice of volume-of-interest delineation algorithm (SUV threshold) may influence FTV. Optimizing PET acquisition time is justified if image quality and quantitation do not deteriorate. The aim of this study is to identify the optimal reconstruction algorithm, SUV threshold and acquisition time for ACE-PET/CT.
ACE-PET/CT data acquired with a General Electric Discovery 690 PET/CT from 16 consecutive high-risk prostate cancer patients was reconstructed with VPHD and SharpIR. Forty pelvic lymph nodes (LNs) and 14 prostate glands were delineated with 42% and estimated threshold. SUVmax, SUVmean, FTV and total lesion uptake were measured. Default acquisition time was four minutes per bed position. In a subset of lesions, acquisition times of one, two and four minutes were evaluated. Structural tumor volumes (STV) of the LNs were measured with CT for correlation with functional volumetric parameters. To validate SUV quantification under different conditions with SharpIR 42%, recovery coefficients (RCs) of SUVmean and FTV were calculated from a phantom with 18F-fluoro-deoxy-glucose (FDG)-filled volumes 0.1-9.2cm3 and signal-to-background (S/B) ratios 4.3-15.9.
With SharpIR, SUVmax and SUVmean were higher and FTV lower compared with VPHD, regardless of threshold method, in both prostates and LNs. Total lesion uptake determined with both threshold methods was lower with SharpIR compared with VPHD with both threshold methods, except in subgroup analysis of prostate targets where estimated threshold returned higher values. Longer acquisition times returned higher FTV for both threshold methods, regardless of reconstruction algorithm. The FTV difference was most pronounced with one minute's acquisition per bed position, which also produced visually the highest noise. SUV parameters were unaffected by varying acquisition times. FTV with SharpIR 42% showed the best correspondence with STV. SharpIR 42% gave higher RCs of SUVmean and FTV with increasing phantom size and S/B-ratio, as expected.
Delineation with SharpIR 42% seems to provide the most accurate combined information from SUVmax, SUVmean, FTV and total lesion uptake. Acquisition time may be shortened to two minutes per bed position with preserved image quality.
11C-乙酸盐(ACE)-PET/CT 用于高危前列腺癌的分期。使用迭代算法(如 VUEPointHD ViP(VPHD)和 VUEPoint HD Sharp IR(SharpIR))对 PET 数据进行重建,后者具有额外的分辨率恢复功能。预计分辨率恢复算法应比普通 OSEM 更准确地提供最大和平均标准化摄取值(SUVmax 和 SUVmean)和功能肿瘤体积(FTV)。进行定量分析时,选择感兴趣区勾画算法(SUV 阈值)可能会影响 FTV。如果图像质量和定量不恶化,则优化 PET 采集时间是合理的。本研究的目的是确定 ACE-PET/CT 的最佳重建算法、SUV 阈值和采集时间。
从 16 例连续的高危前列腺癌患者中使用通用电气 Discovery 690 PET/CT 采集 ACE-PET/CT 数据,使用 VPHD 和 SharpIR 进行重建。用 42%的估计阈值勾画 42 个盆腔淋巴结(LN)和 14 个前列腺。测量 SUVmax、SUVmean、FTV 和总病变摄取。默认采集时间为每个床位 4 分钟。在病变的一个亚组中,评估了 1、2 和 4 分钟的采集时间。用 CT 测量 LN 的结构肿瘤体积(STV),以与功能体积参数相关联。为了验证不同条件下使用 SharpIR 42%的 SUV 定量,使用 18F-氟代脱氧葡萄糖(FDG)填充体积为 0.1-9.2cm3 和信号与背景(S/B)比为 4.3-15.9 的体模计算 SUVmean 和 FTV 的恢复系数(RC)。
使用 SharpIR,与 VPHD 相比,无论阈值方法如何,在前列腺和 LN 中,SUVmax 和 SUVmean 更高,FTV 更低。使用两种阈值方法确定的总病变摄取量均低于 SharpIR 和 VPHD 两种阈值方法,除了前列腺靶区的亚组分析,其中估计阈值返回了更高的值。对于两种阈值方法,更长的采集时间都会产生更高的 FTV,而与重建算法无关。对于每个床位 1 分钟的采集时间,FTV 差异最为明显,这也产生了最高的视觉噪声。SUV 参数不受采集时间变化的影响。使用 SharpIR 42%的 FTV 与 STV 具有最佳的相关性。SharpIR 42%随着体模大小和 S/B 比的增加,SUVmean 和 FTV 的 RC 更高,这是预期的。
SharpIR 42%的勾画似乎提供了来自 SUVmax、SUVmean、FTV 和总病变摄取的最准确的综合信息。如果图像质量保持不变,采集时间可以缩短至每个床位 2 分钟。