Suppr超能文献

电子废物热解处置过程中硝基和含氧多环芳烃的排放行为。

Emission behaviors of nitro- and oxy-polycyclic aromatic hydrocarbons during pyrolytic disposal of electronic wastes.

机构信息

Key Laboratory for Earth Surface Processes, College of Urban and Environmental Sciences, Peking University, Beijing 100871, China.

Key Laboratory for Earth Surface Processes, College of Urban and Environmental Sciences, Peking University, Beijing 100871, China.

出版信息

Chemosphere. 2019 May;222:267-274. doi: 10.1016/j.chemosphere.2019.01.125. Epub 2019 Jan 23.

Abstract

Emission factors (EFs) of polycyclic aromatic hydrocarbon (PAH) derivatives (12 nitro-PAHs and 4 oxy-PAHs) during the pyrolysis of two types of electronic waste (E-waste) were measured. Compositional profile, particle size distribution, gas-particle partitioning, correlations with precursor species and influences of pyrolytic temperature were investigated. The derivative products were dominated by oxy-PAHs. The averaged EFs of oxy-PAHs were 3.37 ± 4.10 μg/g and 32.6 ± 18.1 μg/g for PWBs and plastic casings, respectively, and those of nitro-PAHs were 85.7 ± 92.4 ng/g and 83.3 ± 69.7 ng/g, respectively. Most EFs of derivative species significantly correlated with their corresponding parent PAHs (p < 0.05), except a few cases, indicating formation of derivatives via related reactions of parent species. Most nitro-PAHs occurred in fine particles with the size < 2.1 μm, and oxy-PAHs were prevailing in fine particles with the size between 0.4 μm and 2.1 μm. Proportions of oxy-PAHs in particulate phase, especially those with higher molecular weight, were noticeably greater than those of the corresponding parent species. Below 480 °C, there was no evident difference in the EFs of PAH derivatives, while the EFs noticeably increased from 520 °C. With the increasing temperature, the majority of oxy-PAHs still occurred on finer particles, while the contribution of coarser particles tended to increase.

摘要

测定了两种类型电子废物(电子废物)热解过程中多环芳烃(PAH)衍生物(12 硝基-PAH 和 4 氧基-PAH)的排放因子(EFs)。研究了组成分布、粒径分布、气粒分配、与前体物质的相关性以及热解温度的影响。衍生产物主要为氧基-PAH。PWB 和塑料外壳中氧基-PAH 的平均 EF 分别为 3.37±4.10μg/g 和 32.6±18.1μg/g,硝基-PAH 的平均 EF 分别为 85.7±92.4ng/g 和 83.3±69.7ng/g。除少数情况外,大多数衍生物种的 EF 与相应的母体 PAH 显著相关(p<0.05),表明衍生物种是通过母体物质的相关反应形成的。大多数硝基-PAH 存在于小于 2.1μm 的细颗粒中,而氧基-PAH 主要存在于 0.4μm 至 2.1μm 的细颗粒中。颗粒相中的氧基-PAH 比例,尤其是那些具有较高分子量的氧基-PAH 比例明显大于相应的母体物质。在 480°C 以下,PAH 衍生物的 EF 没有明显差异,而从 520°C 开始 EF 明显增加。随着温度的升高,大多数氧基-PAH 仍存在于更细的颗粒上,而较粗颗粒的贡献趋于增加。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验