Yang Hee Chul, Chang Hye Young
Center for Lung Cancer, Research Institute and Hospital, National Cancer Center, Goyang, Korea.
Bio-Medical Research Institute, Kyungpook National University, Daegu, Korea.
J Thorac Dis. 2018 Dec;10(12):6472-6474. doi: 10.21037/jtd.2018.11.34.
Prolonged air leak is the most common complication after pulmonary resection surgery. Water submersion test (WST) has been used to check for air leak. However, it is cumbersome under the circumstances of video-assisted thoracic surgery (VATS). This study aimed to devise a new air leak detection method that is suitable for the VATS.
We decided to utilize the properties of the surfactants to overcome the disadvantages of WST. To find the optimal surfactant, porcine lung experiments were prepared with a custom-made large glass vessel mimicking a human thoracic cavity. A fresh lung was put inside the glass vessel and connected with the ventilator. We made a needle injury on the lung surface and dropped various kinds of liquid surfactants to create air bubbles during the lung ventilation. The appearances of bubbles were recorded through 5mm thoracoscope.
Considering the bubble forming ability, Pluronic F-127 solution (PF127), a well-known non-toxic and non-ionic colorless surfactant, was chosen as candidate substance. To find the optimal condition, various concentrations of PF127 (30%, 25%, 20%, 15%, 10%) were tested. Greater than 20% concentration of PF127 were not feasible due to its high viscosity; the bubbles kept increasing in size without popping and blocked the thoracoscopic vision. The 10% PF127 did not form any bubbles. On the contrary, the 15% PF127 formed bubbles that are 1-2 cm in size with dynamic movement allowing for clear visibility of the air leak point. We finally made a green colored 15% PF127 by mixing an indocyanine green to increase its visibility. All of the components in the solution are FDA approved and permissible to be used in the human body.
Our bubble solution can easily detect the air leak even in small quantities and is expected to be useful in VATS with limited vision. However, in order for its full-scale clinical use, its safety in the human body must be verified.
漏气时间延长是肺切除术后最常见的并发症。水浸试验(WST)已被用于检查漏气情况。然而,在电视辅助胸腔镜手术(VATS)的情况下,该方法操作繁琐。本研究旨在设计一种适用于VATS的新型漏气检测方法。
我们决定利用表面活性剂的特性来克服WST的缺点。为了找到最佳的表面活性剂,我们用一个模仿人体胸腔的定制大玻璃容器进行了猪肺实验。将一个新鲜的肺放入玻璃容器中并与呼吸机相连。我们在肺表面造成针刺损伤,并在肺通气过程中滴加各种液体表面活性剂以产生气泡。通过5毫米胸腔镜记录气泡的出现情况。
考虑到气泡形成能力,选择了一种著名的无毒非离子无色表面活性剂普朗尼克F-127溶液(PF127)作为候选物质。为了找到最佳条件,测试了各种浓度的PF127(30%、25%、20%、15%、10%)。由于其高粘度,浓度大于20%的PF127不可行;气泡不断增大而不破裂,阻塞了胸腔镜视野。10%的PF127没有形成任何气泡。相反,15%的PF127形成了大小为1-2厘米的气泡,动态移动,使漏气点清晰可见。我们最终通过混合吲哚菁绿制成了绿色的15% PF127,以提高其可见性。溶液中的所有成分均已获得美国食品药品监督管理局(FDA)批准,可用于人体。
我们的气泡溶液即使在少量情况下也能轻松检测到漏气,预计在视野有限的VATS中有用。然而,为了其全面临床应用,必须验证其在人体中的安全性。