Department of Chemistry, Universidad de La Laguna, P.O. Box 456, E-38200, La Laguna (Tenerife), Spain.
Department of Chemical Engineering and Pharmaceutical Technology, Universidad de La Laguna, P.O. Box 456, E-38200, La Laguna (Tenerife), Spain.
J Environ Manage. 2019 Sep 15;246:472-483. doi: 10.1016/j.jenvman.2019.05.147. Epub 2019 Jun 12.
Excessive fluoride content in groundwater can cause serious risks to human health, and sources of groundwater intended for human consumption should be treated to reduce fluoride concentrations down to acceptable levels. In the particular case of the island of Tenerife (Canary Islands, Spain), the water supply comes mainly from aquifers of volcanic origin with a high content of fluorides that make them unacceptable for human consumption without prior conditioning treatment. The treatments that generate a high rejection of water are not acceptable because water is a scarce natural resource of high value. An electrocoagulation process was investigated as a method to treat natural groundwater from volcanic soils containing a hazardously high fluoride content. The operating parameters of an electrocoagulation reactor model with parallel plate aluminum electrodes were optimized for batch and continuous flow operations. In the case of the batch operation, acidification of the water improved the removal efficiency of fluoride, which was the highest at pH 3. However, operation at the natural pH of the water achieved elimination efficiencies between 82 and 92%, depending on the applied current density. An optimum current density of 5 mA/cm was found in terms of maximum removal efficiency, and the kinetics of fluoride removal conformed to pseudo-second-order kinetics. In the continuous-flow operation, with the optimal residence time of 10 min and a separation of 0.5 cm between the electrodes, it was observed that the current density that would be applied would depend on the initial concentration of fluoride in the raw water. Thus, an initial fluoride concentration of 6.02 mg/L required a current density >7.5 mA/cm to comply with the legal guidelines in the product water, while for an initial concentration of 8.98 mg/L, the optimal current density was 10 mA/cm. Under these operating conditions, the electrocoagulation process was able to reduce the fluoride concentration of natural groundwater to below 1.5 mg/L according to WHO guidelines with an operating cost between 0.20 and 0.26 €/m of treated water.
地下水中过量的氟含量会对人类健康造成严重威胁,因此供人类饮用的地下水水源应经过处理,将氟浓度降低到可接受的水平。在特内里费岛(西班牙加那利群岛)的特殊情况下,水供应主要来自火山成因的含水层,这些含水层含有高浓度的氟化物,如果不经预处理,这些水不适合人类饮用。那些产生高水拒斥率的处理方法是不可接受的,因为水是一种具有高价值的稀缺自然资源。本研究调查了电絮凝工艺作为一种处理源自火山土壤的高氟含量天然地下水的方法。优化了带有平行板铝电极的电絮凝反应器模型的批处理和连续流动操作的运行参数。在批处理操作中,酸化水可提高氟化物的去除效率,在 pH 值为 3 时达到最高。然而,在水的自然 pH 值下操作可实现 82%至 92%之间的消除效率,这取决于所施加的电流密度。在最大去除效率方面,发现最佳电流密度为 5 mA/cm,氟化物去除动力学符合准二级动力学。在连续流动操作中,最优停留时间为 10 分钟,电极之间的分离为 0.5 厘米,观察到将施加的电流密度取决于原水的初始氟化物浓度。因此,初始氟化物浓度为 6.02 mg/L 时,需要>7.5 mA/cm 的电流密度才能符合产品水中的法规指南,而初始浓度为 8.98 mg/L 时,最佳电流密度为 10 mA/cm。在这些操作条件下,电絮凝工艺能够将天然地下水中的氟化物浓度降低到低于 1.5 mg/L,符合世界卫生组织的指南,运行成本为处理每立方米水 0.20 至 0.26 欧元。