Aksoy Aslı, Karasu Salih, Akcicek Alican, Kayacan Selma
Department of Food Engineering, Faculty of Chemical and Metallurgical, Yildiz Technical University, Esenler, İstanbul 34210, Turkey.
Foods. 2019 Jun 18;8(6):216. doi: 10.3390/foods8060216.
This study aimed to investigate the effect of different drying methods, namely ultrasound-assisted vacuum drying (USV), vacuum drying (VD), and freeze-drying (FD), on the drying kinetics and some quality parameters of dried minced meat. In this study, USV was for the first time applied to the drying of minced meat. The USV and VD methods were conducted at 25 °C, 35 °C, and 45 °C. The different drying methods and temperatures significantly affected the drying time ( < 0.05). The USV method showed lower drying times at all temperatures. The rehydration values of the freeze-dried minced meat samples were higher than those obtained by the USV and VD techniques. The samples prepared using USV showed higher rehydration values than the vacuum dried samples for all temperatures. The effects of the different drying techniques and drying conditions on the microstructural properties of the minced meat samples were investigated using scanning electron microscope (SEM). The USV method resulted in higher porosity and a more open structure than the VD method. Total color differences (Δ) for VD, USV, and FD were 8.27-20.81, 9.58-16.42, and 9.38, respectively, and were significantly affected by the drying methods and temperatures ( < 0.05). Higher drying temperature increased the Δ value. Peroxide values (PV) significantly increased after the drying process, and samples treated with USV showed lower PV values than the VD treated samples. This study suggests that USV could be used as an alternative drying method for minced meat drying due to lower drying times and higher quality parameters.
本研究旨在探讨不同干燥方法,即超声辅助真空干燥(USV)、真空干燥(VD)和冷冻干燥(FD)对碎肉干制动力学及一些品质参数的影响。在本研究中,USV首次应用于碎肉干燥。USV和VD方法在25℃、35℃和45℃下进行。不同的干燥方法和温度对干燥时间有显著影响(<0.05)。USV方法在所有温度下干燥时间均较短。冷冻干燥碎肉样品的复水值高于USV和VD技术获得的值。在所有温度下,采用USV制备的样品的复水值均高于真空干燥样品。使用扫描电子显微镜(SEM)研究了不同干燥技术和干燥条件对碎肉样品微观结构性质的影响。与VD方法相比,USV方法导致更高的孔隙率和更开放的结构。VD、USV和FD的总色差(Δ)分别为8.27 - 20.81、9.58 - 16.42和9.38,且受干燥方法和温度的显著影响(<0.05)。较高的干燥温度增加了Δ值。干燥过程后过氧化值(PV)显著增加,USV处理的样品的PV值低于VD处理的样品。本研究表明,由于干燥时间较短且品质参数较高,USV可作为碎肉干燥的替代干燥方法。