Estimation of potential arsenic leaching from its phases in excavated sedimentary and metamorphic rocks.

It is important that hazardous excavated sedimentary and metamorphic rocks are treated appropriately and reused without posing an environmental risk. Up-flow column leaching tests were conducted to examine whether arsenic leaching behavior varied among five hazardous excavated sedimentary and metamorphic rocks (two mudstones, clay sediment of marine origin, slate, and black schist) and to determine whether the potential amount of arsenic leaching could be estimated based on the arsenic-bearing mineral phases in the rock. Changes in arsenic concentration with pore volume (PV) showed the same pattern across all rock types, except for one that contained an extremely low amount of water-soluble arsenic, exhibiting an initial increase to reach a peak, followed by a decrease. The arsenic amounts leached before and after the PV at which the arsenic concentration peaked, corresponded to 88% ± 20% of the amount of arsenic fraction 1 obtained by sequential extraction and 76% ± 10% of the amount of arsenic fraction 2, respectively, while the potential amount of arsenic leaching corresponded to 65-89% of the summed total of arsenic fractions 1 + 2. These findings indicate that arsenic exhibits the same leaching behavior among different types of hazardous excavated sedimentary and metamorphic rocks except where extremely low amounts of water-soluble arsenic are present and that the potential amount of arsenic leaching can be approximated by calculating the summed total of arsenic fractions 1 + 2, which allows us to estimate the minimum amount of material required for treatments such as immobilization conducted to prevent arsenic leaching.