Surface reconstruction of AgPd nanoalloy particles during the electrocatalytic formate oxidation reaction.

Formate is a kind of carbon-neutral fuel that can be synthesized by electrochemical conversion of CO, however, the generated aqueous formate electrolyte is still short of potential application. Here, formate solution is proposed to be utilized as anode fuels of direct formate fuel cells through the formate oxidation reaction (FOR), and graphene supported AgPd nanoalloys (AgPd/rGO) are prepared to catalyze the FOR. Specifically, the mass activity of the as-prepared AgPd/rGO catalyst is 4.21 A mg and the retention activity of AgPd/rGO is 49.1% of initial activity after successive 500 cycles, which is 2.48 and 3.03 times higher than that of unsupported AgPd nanoalloys. When increasing the positive scan limit from 0.0 to 0.8 V, the mass activity of the AgPd/rGO catalyst increases from 2.32 to 6.03 A mg and Pd surface coverage increases from 51.87% to 62.42%, indicating the occurrence of surface reconstruction where Pd atoms migrate to the surface of AgPd nanoalloys, and less intensive reconstruction is observed in unsupported AgPd nanoalloys, whose mass activity increases from 1.35 to 2.49 A mg. The driving force and kinetic path are calculated for the surface reconstruction induced by the adsorption of H, O and C atoms, in the case of C atoms on graphene, the segregation energy of surface Pd atoms in the AgPd nanoalloy is -1.16 eV, and the activation energy for the migration of subsurface Pd atoms to the surface is 0.54 eV, which are lower than the segregation (0.03 eV) and activation (2.06 eV) energy on a clean alloy surface.