Dept. of Ophthalmology, University of Muenster Medical Center, Albert-Schweitzer-Campus 1, Building D15, 48149, Muenster, Germany.
Graefes Arch Clin Exp Ophthalmol. 2020 May;258(5):1065-1071. doi: 10.1007/s00417-019-04566-x. Epub 2020 Jan 31.
To evaluate different corneal parameters in identifying patients at risk of a hyperopic shift after (DMEK).
This retrospective study included 92 eyes of patients with FECD after DMEK surgery. Pachymetry parameters, various tomographic parameters and densitometry values before and after DMEK were determined using a rotating Scheimpflug system (Pentacam HR, Oculus). For assessing the posterior to anterior corneal curvature relationship, we calculated the R (posterior to anterior corneal curvature radii ratio).
The average keratometry reading of the posterior corneal surface (Km increased and the total corneal refractive power (TCRP) decreased significantly after surgery (P < .001). There was a significant difference between the preoperative and postoperative R (P < .001) and the posterior Q value (P < .001). The strongest correlation was found between the change in the Km and the preoperative R (Spearman's correlation coefficient = 0.872, P < .001). In the receiver operating characteristic (ROC) analysis, the highest AUC values (for ∆Km) among the different preoperative parameters tested were obtained for R and posterior Q value (Asph. Q) with AUROC (area under the ROC) values of 0.95 and 0.89, respectively.
The Q value and the R showed the highest correlation with the change in corneal refractive power and the greatest AUC. These parameters could be used as surrogate markers to identify eyes that might be at risk of a greater postoperative hyperopic shift, which would allow more accurate setting of refractive goals.
评估不同的角膜参数在识别(DMEK)后发生远视漂移风险患者中的作用。
本回顾性研究纳入了 92 例接受 DMEK 手术后发生 FECD 的患者的 92 只眼。使用旋转 Scheimpflug 系统(Pentacam HR,Oculus)确定术前和术后的角膜厚度参数、各种断层扫描参数和密度测量值。为评估前后角膜曲率关系,我们计算了 R(前后角膜曲率半径比)。
术后平均角膜后表面角膜曲率读数(Km)增加,总角膜屈光力(TCRP)显著降低(P<.001)。术前和术后 R(P<.001)和后 Q 值(P<.001)之间存在显著差异。Km 的变化与术前 R 之间的相关性最强(Spearman 相关系数=0.872,P<.001)。在受试者工作特征(ROC)分析中,在测试的不同术前参数中,Km 的变化与 R 和后 Q 值(Asph. Q)的 AUC 值最高(R 和后 Q 值的 AUC 值分别为 0.95 和 0.89)。
Q 值和 R 与角膜屈光力的变化相关性最高,AUC 最大。这些参数可以用作替代标志物,以识别可能存在更大术后远视漂移风险的眼睛,从而可以更准确地设定屈光目标。