Sorainen E
Kuopio Regional Institute of Occupational Health, Finland.
Am Ind Hyg Assoc J. 1988 Dec;49(12):A775-8.
The vibration in nine halls of the six weaving mills was measured in 1978-80. The measurements were taken at regular intervals in the working area of the weavers, which was the wooden support attached to the machine or the floor of the textile mill. The accelerometer was mounted with screws onto the working area, and all vibration samples were analyzed immediately, in situ. The vibration of the floor was tangent to or exceeded slightly the "reduced comfort boundary" specified in International Standard ISO 2631/1 (1985) only in the areas where the floor was not against the ground. The greatest amount of vibration occurred on the supports which had been attached to the machines. On these supports the vibration in places exceeded the "fatigue-decreased proficiency boundary."
1978年至1980年期间，对六家织布厂九个车间的振动情况进行了测量。测量是在织布工人的工作区域定期进行的，该区域是连接到机器上的木制支架或纺织厂的地面。加速度计用螺丝安装在工作区域上，所有振动样本都在现场立即进行分析。只有在地面不靠墙的区域，地面振动才略微相切或超过国际标准ISO 2631/1（1985）规定的“降低舒适度界限”。最大量的振动发生在连接到机器上的支架上。在这些支架上，某些地方的振动超过了“疲劳导致熟练程度下降界限”。
