Suppr超能文献

优化生物污泥的堿性水热预处理以提高厌氧条件下的甲烷生成。

Optimization of alkaline hydrothermal pretreatment of biological sludge for enhanced methane generation under anaerobic conditions.

机构信息

Environmental Engineering Department, Akdeniz University, 07058 Antalya, Turkey.

Environmental Engineering Department, Akdeniz University, 07058 Antalya, Turkey.

出版信息

Waste Manag. 2020 Apr 15;107:9-19. doi: 10.1016/j.wasman.2020.03.033. Epub 2020 Apr 2.

Abstract

This paper investigated the effect of alkaline hydrothermal pretreatment (HTP) on the hydrolysis, biodegradation and methane generation potential of waste activated sludge (WAS). A multi-variable experimental approach was designed, where initial solids content (1-5%), reaction temperature (130-190 °C), reaction time (10-30 min.) and caustic concentration (0-0.2 mgNaOH/mgVS) were varied in different combinations to assess the impact of alkaline HTP. This process significantly enhanced the hydrolysis of organic compounds in sludge into soluble fractions, whereby increasing the chemical oxygen demand (COD) leakage up to 200-900% with the 17-99% solubility. It boosted volatile solids (VS) biodegradation up to 40%, which resulted in a parallel increase in methane generation from 216 mLCH/gVS to as high a 456 mLCH/gVS methane generation basically relied on the conversion of solubilized COD. Alkaline HTP process was optimized for the maximum methane production. Optimum conditions were obtained at 190 °C reaction temperature, 10 min. reaction time, 0.2 mgNaOH/mgVS and 5% dry matter content. Under these conditions, 453.8 mLCH/gVS was predicted. Biochemical methane potential (BMP) value was determined as 464 mLCH/gVS supporting predictive power of the BMP model. The biodegradability compared to the untreated raw WAS was enhanced 78.2%.

摘要

本文研究了碱性水热预处理(HTP)对废活性污泥(WAS)水解、生物降解和甲烷生成潜力的影响。采用多变量实验方法,设计了不同的初始固体含量(1-5%)、反应温度(130-190°C)、反应时间(10-30 分钟)和苛性碱浓度(0-0.2mgNaOH/mgVS)组合,以评估碱性 HTP 的影响。该工艺显著提高了污泥中有机化合物的水解效率,将化学需氧量(COD)的泄漏率提高了 200-900%,溶解度提高了 17-99%。同时,挥发性固体(VS)的生物降解率提高了 40%,这导致甲烷生成量从 216 mLCH/gVS 增加到 456 mLCH/gVS。甲烷的生成主要依赖于可溶性 COD 的转化。对碱性 HTP 工艺进行了优化,以获得最大的甲烷产量。在 190°C 的反应温度、10 分钟的反应时间、0.2mgNaOH/mgVS 和 5%干物质含量的最优条件下,预测甲烷产量为 453.8 mLCH/gVS。生化甲烷潜力(BMP)值为 464 mLCH/gVS,支持 BMP 模型的预测能力。与未经处理的原始 WAS 相比,生物降解性提高了 78.2%。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验