Luo T David, De Gregorio Michael, Zuskov Andrey, Khalil Mario, Li Zhongyu, Nuñez Fiesky A, Nuñez Fiesky A
Department of Orthopaedic Surgery, Wake Forest Baptist Medical Center, Winston Salem, North Carolina.
Bon Secours Orthopaedic, Greenville, South Carolina.
J Wrist Surg. 2020 Apr;9(2):100-104. doi: 10.1055/s-0039-1695707. Epub 2019 Aug 28.
To compare the biomechanical characteristics between diaphyseal and metaphyseal ulnar-shortening osteotomy with respect to (1) maximal shortening achieved at each osteotomy site and (2) force required to achieve shortening at each site. Nine fresh frozen cadaveric upper extremities were affixed through the proximal ulna to a wooden surgical board. A metaphyseal 20-mm bone wedge was resected from the distal ulna and sequential shortening was performed. A load cell was attached to a distal post that was clamped to the surgical board and used to measure the force required for each sequential 5-mm of shortening until maximal shortening was achieved. The resected bone was reinserted, and plate fixation was used to restore normal anatomy. A 20-mm diaphyseal osteotomy was performed, and force measurements were recorded in the same manner with (1) interosseous membrane intact, (2) central band released, and (3) extensive interosseous membrane and muscular attachments released. Metaphyseal osteotomy allowed greater maximal shortening than diaphyseal osteotomy with the interosseous membrane intact and with central band release but similar shortening when extensive interosseous membrane and muscle release was performed. Force at maximal shortening was similar between metaphyseal and diaphyseal osteotomy. Sequential soft tissue release at the diaphysis allowed for increased shortening with slightly decreased shortening force with sequential release. Metaphyseal ulnar osteotomy allows greater maximal shortening but requires similar force compared with diaphyseal osteotomy. Sequential release of the interosseous membrane permits increased shortening at the diaphysis but requires extensive soft tissue release. Both sites of osteotomy can achieve sufficient shortening to decompress the ulnocarpal joint for most cases of ulnar impaction syndrome. The greater shortening from metaphyseal ulnar osteotomy may be reserved for severe cases of shortening, especially after distal radius malunion or in the setting of distal radius growth arrest in the pediatric population. This is a Level V, basic science study.
比较尺骨干和干骺端截骨术的生物力学特征,涉及以下方面:(1)每个截骨部位实现的最大缩短量;(2)在每个部位实现缩短所需的力。
将9个新鲜冷冻的尸体上肢通过尺骨近端固定在木制手术板上。从尺骨远端切除一个20毫米的干骺端骨楔,并进行连续缩短。将一个测力传感器连接到一个夹在手术板上的远端柱上,用于测量每次连续5毫米缩短所需的力,直至达到最大缩短量。将切除的骨头重新插入,并用钢板固定以恢复正常解剖结构。进行20毫米的骨干截骨术,并以相同方式记录力的测量值,包括:(1)骨间膜完整;(2)中央束松解;(3)广泛的骨间膜和肌肉附着点松解。
在骨间膜完整和中央束松解的情况下,干骺端截骨术比骨干截骨术允许更大的最大缩短量,但在进行广泛的骨间膜和肌肉松解时,两者缩短量相似。最大缩短时的力在干骺端和骨干截骨术之间相似。骨干处的连续软组织松解允许增加缩短量,同时随着连续松解,缩短力略有下降。
与骨干截骨术相比,尺骨干骺端截骨术允许更大的最大缩短量,但所需力相似。骨间膜的连续松解允许骨干处增加缩短量,但需要广泛的软组织松解。
对于大多数尺骨撞击综合征病例,两个截骨部位都可以实现足够的缩短以减压尺腕关节。尺骨干骺端截骨术更大的缩短量可能适用于严重缩短的病例,特别是在桡骨远端畸形愈合后或儿科人群桡骨远端生长停滞的情况下。
这是一项V级基础科学研究。