Development of in-bore magnetostrictive transducer for ultrasonic guided wave based-inspection of steam generator tubes of PFBR.

An in-bore magnetostrictive transducer is designed for the steam generator tubes of Prototype fast breeder reactor for the generation of L(0,2) modes of frequencies in the range of 250-350 kHz. Towards this, axi-symmetric finite element models are developed to optimize the coil parameters. The optimized length of the transmitter and the receiver coils turns out to be 10 mm (~half the wavelength) for the frequency of 300 kHz. The optimized width of the coils turns out to be 0.46 mm. FE models also show the generation, propagation and reception of L(0,2) modes in the frequency range of 250-350 kHz. The role of skin effect in the magnetostrictive based-generation of L(0,2) modes with frequency is also discussed. A transducer is designed based on the FE results. The transducer is tested for the generation of L(0,2) mode in the frequency range of 250-350 kHz in a 1 m long steam generator tube segment. A good agreement is observed between FE and experimental normalized amplitudes and the times of flight for different frequencies. L(0,2) modes are found to generate and propagate and received, as predicted by the finite element simulations. An excellent agreement is observed between the experimentally measured group velocities with those obtained from the dispersion curves in this frequency range. Experiments show the signal to noise ratio to be better than 15 dB. To ascertain the utility of the transducer in steam generator tubes for the long range testing, L(0,2) mode at 300 kHz frequency is propagated in a 1.5 m long tube. The resulted multiple end reflections amount to the propagation of 51 m distance. To check the capability of detection of defects, a short tube with a full circumferential defect of depth 0.46 mm (20%WT) and a short tube with a pin hole of 1.5 mm diameter are considered. Further, FE results for the case of the axi-symmetric circumferential defect are validated experimentally. For the case of the pinhole (non-axi-symmetric), the experimental signal to noise ratio turns out to be 6 dB, which is only 6 dB lower as compared to that obtained using a piezo based ultrasonic transducer of frequency 300 kHz coupled to the end of the tube.