Biological and Environmental Science and Engineering, King Abdullah University of Science and Technology (KAUST), Thuwal 23955-6900, Saudi Arabia.
Department of Physics and Astronomy, University of Texas at San Antonio, San Antonio, Texas 78249, United States.
Anal Chem. 2020 Jun 2;92(11):7762-7769. doi: 10.1021/acs.analchem.0c00890. Epub 2020 May 13.
Conventional immunosensors typically rely on passive diffusion dominated transport of analytes for binding reaction and hence, it is limited by low sensitivity and long detection times. We report a simple and efficient impedance sensing method that can be utilized to overcome both sensitivity and diffusion limitations of immunosensors. This method incorporates the structural advantage of nanorod-covered interdigitated electrodes and the microstirring effect of AC electrothermal flow (ACET) with impedance spectroscopy. ACET flow induced by a biased AC electric field can rapidly convect the analyte onto nanorod structured electrodes within a few seconds and enriches the number of binding molecules because of the excessive effective surface area. We performed numerical simulations to investigate the effect of ACET flow on the biosensor performance. The results indicated that AC bias to the side electrodes could induce fast convective flow, which facilitates the transport of the target molecules to the binding region located in the middle as a floating electrode. The temperature rise due to the Joule heating effect was measured using a thermoreflectance imaging method to find the optimum device operation conditions. The change of impedance caused by the receptors-target molecules binding at the sample/electrode interface was experimentally measured and quantified in real-time using the impedance spectroscopy technique. We observed that the impedance sensing method exhibited extremely fast response compared with those under no bias conditions. The measured impedance change can reach saturation in a minute. Compared to the conventional incubation method, the ACET flow enhanced method is faster in its reaction time, and the detection limit can be reduced to 1 ng/mL. In this work, we demonstrate that this sensor technology is promising and reliable for rapid, sensitive, and real-time monitoring of biomolecules in biologically relevant media such as blood, urine, and saliva.
传统的免疫传感器通常依赖于分析物的被动扩散主导的传输来进行结合反应,因此,它受到低灵敏度和长检测时间的限制。我们报告了一种简单而有效的阻抗传感方法,可以克服免疫传感器的灵敏度和扩散限制。该方法结合了纳米棒覆盖的叉指电极的结构优势和交流电热流(ACET)的微搅拌效应与阻抗谱。偏置交流电场引起的 ACET 流可以在几秒钟内将分析物快速对流到纳米棒结构电极上,并由于过大的有效表面积而富集结合分子的数量。我们进行了数值模拟,以研究 ACET 流对生物传感器性能的影响。结果表明,交流偏置到侧电极可以诱导快速的对流流动,从而促进目标分子向位于中间的浮动电极的结合区域的传输。使用热反射成像方法测量由于焦耳加热效应引起的温度升高,以找到最佳的器件操作条件。使用阻抗谱技术实时测量和定量测量由于受体-靶分子在样品/电极界面的结合而引起的阻抗变化。我们观察到,与无偏置条件下相比,阻抗传感方法表现出极快的响应。阻抗的测量变化可在一分钟内达到饱和。与传统的孵育方法相比,ACET 流增强方法在反应时间上更快,检测限可降低至 1ng/mL。在这项工作中,我们证明了这种传感器技术在快速、灵敏和实时监测生物相关介质(如血液、尿液和唾液)中的生物分子方面是有前途和可靠的。