Modeling and Piezoelectric Analysis of Nano Energy Harvesters.

The expedient way for the development of microelectromechanical systems (MEMS) based devices are based on two key steps. First, perform the simulation for the optimization of various parameters by using different simulation tools that lead to cost reduction. Second, develop the devices with accurate fabrication steps using optimized parameters. Here, authors have performed a piezoelectric analysis of an array of zinc oxide (ZnO) nanostructures that have been created on both sides of aluminum sheets. Various quantities like swerve, stress, strain, electric flux, energy distribution, and electric potential have been studied during the piezo analysis. Then actual controlled growth of ZnO nanorods (NRs) arrays was done on both sides of the etched aluminum rod at low-temperature using the chemical bath deposition (CBD) method for the development of a MEMS energy harvester. Micro creaks on the substrate acted as an alternative to the seed layer. The testing was performed by applying ambient range force on the nanostructure. It was found that the voltage range on topside was 0.59 to 0.62 mV, and the bottom side was 0.52 to 0.55 mV. These kinds of devices are useful in low power micro-devices, nanoelectromechanical systems, and smart wearable systems.