Ma Tianlin, Ding Jianfei, Liu Xueli, Chen Gangling, Zheng Jiandong
School of Materials and Chemical Engineering, Chuzhou University, Chuzhou 239000, China.
School of Chemistry and Chemical Engineering, Yancheng Institute of Technology, Yancheng 224051, China.
J Nanosci Nanotechnol. 2020 Dec 1;20(12):7680-7685. doi: 10.1166/jnn.2020.18873.
We investigated the catalytic performance of glycerol conversion to acrolein on nickel phosphates samples (NiP-T ( = 300,400,500,600, and 700 °C)). The textural property, acidity of the fresh catalyst and carbon content of the used NiP-500 were also determined. The results showed that NiP was amorphous under the appropriate calcination temperature. The textural property, acid amount and strength were important in this reaction. Glycerol conversion was proportional to the acid amount of the sample. After 2 h on stream, NiP-500 with the largest pore size, largest acid amount and largest number of moderate acid sites had the maximum catalytic performance (89% glycerol conversion and 64% acrolein selectivity). NiP-700 showed the lowest performance (48% glycerol conversion and 34% acrolein selectivity), which is due to the lowest surface area, pore size and the lowest acid amount of NiP-700. Moreover, the catalyst deactivation was ascribed to carbon deposition on phosphates during the reaction.
我们研究了磷酸镍样品(NiP-T,T = 300、400、500、600和700℃)上甘油转化为丙烯醛的催化性能。还测定了新鲜催化剂的织构性质、酸度以及使用过的NiP-500的碳含量。结果表明,在适当的煅烧温度下,NiP为非晶态。织构性质、酸量和强度在该反应中很重要。甘油转化率与样品的酸量成正比。反应2小时后,孔径最大、酸量最大且中等酸位数量最多的NiP-500具有最高的催化性能(甘油转化率89%,丙烯醛选择性64%)。NiP-700表现出最低的性能(甘油转化率48%,丙烯醛选择性34%),这是由于NiP-700的表面积、孔径和酸量最低。此外,催化剂失活归因于反应过程中磷酸盐上的积碳。