Suppr超能文献

两步 pH 值控制法通过诱导层状双氢氧化物的形成,从近中性矿山和冶金废水排放中去除二价金属。

A two-step pH control method to remove divalent metals from near-neutral mining and metallurgical waste drainages by inducing the formation of layered double hydroxide.

机构信息

Department of Chemical and Geological Sciences, University of Cagliari, Cagliari, Italy.

Department of Chemical and Geological Sciences, University of Cagliari, Cagliari, Italy.

出版信息

J Environ Manage. 2020 Oct 1;271:111043. doi: 10.1016/j.jenvman.2020.111043. Epub 2020 Jul 10.

Abstract

A neutral M-rich and M-poor (M = metal) metallurgical waste drainage was used to test a metal removal method based on the precipitation of layered double hydroxide (LDH). The LDH precipitation was induced by adding a salt of Al (trivalent metal missing in the drainage) and maintaining or restoring the pH to a circum-neutral value. The precipitates were characterized by chemical analysis, XRD, ESEM, HRTEM and XAS. The main parameter controlling the removal of metals and the type of precipitate appeared to be the pH. As a function of pH variation during the experiments, analyses of precipitates and solutions showed either the formation of poor crystalline LDH combined with very high removal of Zn, Ni and Pb (92-100%), more variable removal of Mn (46-98%) and less Cd (33-40%), or the formation of more crystalline LDH combined with lower removal of Zn (62%), Mn (43%), Ni (88%), Pb (64%) and especially Cd (1%). The different metal removal efficiency in the two cases is only indirectly due to the different LDH crystallinity, and it is clearly affected by the following factors: 1) the two pH steps of the method; 2) the direction of pH variation within each step. In particular, the highest removal of metals is obtained when the first pH step goes towards acidic conditions, as a consequence of Al salt addition, and precipitation of a quasi-amorphous hydrated hydroxysulfate of Al (probably a precursor of felsӧbányaite Al(SO)(OH) · 4HO) occurs. This first acidic pH step removes little or no metals (just 0-3%) but it is essential so that the second pH step towards slightly alkaline conditions, as a consequence of NaOH addition, can be highly efficient in removing divalent metals as the quasi-amorphous hydrated hydroxysulfate of Al gradually turns into an LDH incorporating Zn, Mg and other metals. On the contrary, when both pH steps remain in the neutral-alkaline range, only LDH precipitation occurs and a lower metal removal is observed. These results encourage further investigations on the removal of metals by inducing LDH precipitation as a simple and effective method for the treatment of circum-neutral polluted drainages.

摘要

使用一种中性富 M 和贫 M(M=金属)的冶金废物浸出液来测试一种基于层状双氢氧化物(LDH)沉淀的金属去除方法。通过添加三价金属(浸出液中缺少的金属)的盐并将 pH 值维持或恢复到近中性值来诱导 LDH 沉淀。通过化学分析、XRD、ESEM、HRTEM 和 XAS 对沉淀物进行了表征。控制金属去除的主要参数和沉淀类型似乎是 pH 值。作为实验过程中 pH 值变化的函数,沉淀和溶液的分析表明,要么形成结晶度差的 LDH,并伴有 Zn、Ni 和 Pb 的高去除率(92-100%),Mn 的去除率更可变(46-98%),Cd 的去除率较低(33-40%),要么形成结晶度较高的 LDH,并伴有 Zn(62%)、Mn(43%)、Ni(88%)、Pb(64%)和特别是 Cd(1%)的去除率较低。这两种情况下不同的金属去除效率仅间接归因于 LDH 结晶度的不同,并且显然受到以下因素的影响:1)该方法的两个 pH 步骤;2)每个步骤中 pH 值变化的方向。特别是,当第一个 pH 步骤朝向酸性条件(由于添加 Al 盐)进行时,可以获得最高的金属去除率,并且会发生近乎无定形的水合羟硫酸盐的沉淀 Al(可能是 felsӧbányaite Al(SO)(OH)·4HO 的前体)。第一个酸性 pH 步骤几乎不或不去除金属(仅 0-3%),但这是必要的,因为第二个 pH 步骤朝向微碱性条件(由于添加 NaOH),可以非常有效地去除二价金属,因为近乎无定形的水合羟硫酸盐 Al 逐渐转变为掺入 Zn、Mg 和其他金属的 LDH。相反,当两个 pH 步骤都保持在中性-碱性范围内时,仅发生 LDH 沉淀,观察到金属去除率降低。这些结果鼓励进一步研究通过诱导 LDH 沉淀来去除金属,因为这是一种简单有效的处理近中性污染排水的方法。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验