Bujalowski W, Overman L B, Lohman T M
Department of Biochemistry and Biophysics, Texas A&M University, College Station 77843.
J Biol Chem. 1988 Apr 5;263(10):4629-40.
We have extended our investigations of the multiple binding modes that form between the Escherichia coli single strand binding (SSB) protein and single-stranded DNA (Lohman, T. M. & Overman, L. B. (1985) J. Biol. Chem. 260, 3594-3603; Bujalowski, W. & Lohman, T. M. (1986) Biochemistry 25, 7799-7802) by examining the effects of anions, pH, BaCl2, and protein binding density on the transitions among these binding modes. "Reverse" titrations that monitor the quenching of the intrinsic tryptophan fluorescence of the SSB protein upon addition of poly(dT) have been used to measure the apparent site size of the complex at 25 degrees C in pH 8.1 and 6.9 as a function of NaF, NaCl, NaBr, and MgCl2 concentrations. Under all conditions in which "reverse" titrations were performed, we observe three distinct binding modes with site sizes of 35 +/- 2, 56 +/- 3, and 65 +/- 3 nucleotides/SSB tetramer; however, the transitions among the three binding modes are strongly dependent upon both the cation and anion valence, type, and concentration as well as the pH. A net uptake of both cations and anions accompanies the transitions from the (SSB)35 to the (SSB)56 binding mode at pH 6.9, whereas at pH 8.1 this transition is anion-independent, and only a net uptake of cations occurs. The transition from the (SSB)56 to the (SSB)65 binding mode is dependent upon both cations and anions at both pH 6.9 and 8.1 (25 degrees C), and a net uptake of both cations and anions accompanies this transition. We have also examined the transitions by monitoring the change in the sedimentation coefficient of the SSB protein-poly(dT) complex as a function of MgCl2 concentration (20 degrees C, pH 8.1) and observe an increase in s20,w, which coincides with the increase in apparent site size of the complex, as measured by fluorescence titrations. The frictional coefficient of the complex decreases by a factor of two in progressing from the (SSB)35 to the (SSB)65 binding mode, indicating a progressive compaction of the complex throughout the transition. The transition between the (SSB)35 and the (SSB)56 complex is dependent on the protein binding density, with the lower site size (SSB)35 complex favored at higher binding density. These results indicate that the transitions among the various SSB protein-single-stranded DNA binding modes are complex processes that depend on a number of solution variables that are thermodynamically linked.(ABSTRACT TRUNCATED AT 400 WORDS)
我们通过研究阴离子、pH值、氯化钡和蛋白质结合密度对这些结合模式之间转变的影响,扩展了对大肠杆菌单链结合(SSB)蛋白与单链DNA之间形成的多种结合模式的研究(洛曼,T.M.和奥弗曼,L.B.(1985年)《生物化学杂志》260卷,3594 - 3603页;布亚洛夫斯基,W.和洛曼,T.M.(1986年)《生物化学》25卷,7799 - 7802页)。通过监测加入聚(dT)后SSB蛋白内在色氨酸荧光的淬灭进行的“反向”滴定,已被用于测量在25摄氏度、pH值为8.1和6.9时,作为氟化钠、氯化钠、溴化钠和氯化镁浓度函数的复合物的表观位点大小。在进行“反向”滴定的所有条件下,我们观察到三种不同的结合模式,其位点大小分别为35±2、56±3和65±3个核苷酸/SSB四聚体;然而,这三种结合模式之间的转变强烈依赖于阳离子和阴离子的价态、类型、浓度以及pH值。在pH值为6.9时,从(SSB)35结合模式转变为(SSB)56结合模式伴随着阳离子和阴离子的净摄取,而在pH值为8.1时,这种转变与阴离子无关,仅发生阳离子的净摄取。在pH值为6.9和8.1(25摄氏度)时,从(SSB)56结合模式转变为(SSB)65结合模式依赖于阳离子和阴离子,并且这种转变伴随着阳离子和阴离子的净摄取。我们还通过监测SSB蛋白 - 聚(dT)复合物沉降系数随氯化镁浓度(20摄氏度,pH值为8.1)的变化来研究转变,并观察到s20,w增加,这与通过荧光滴定测量的复合物表观位点大小的增加相一致。从(SSB)35结合模式转变为(SSB)65结合模式时,复合物的摩擦系数降低了两倍,表明在整个转变过程中复合物逐渐压实。(SSB)35和(SSB)56复合物之间的转变取决于蛋白质结合密度,在位点大小较低的(SSB)35复合物在较高结合密度时更受青睐。这些结果表明,各种SSB蛋白与单链DNA结合模式之间的转变是复杂的过程,取决于许多热力学相关的溶液变量。(摘要截断于400字)