Dekker J P, van Gorkom H J
J Bioenerg Biomembr. 1987 Apr;19(2):125-42. doi: 10.1007/BF00762721.
An overview is presented of secondary electron transfer at the electron donor side of Photosystem II, at which ultimately two water molecules are oxidized to molecular oxygen, and the central role of manganese in catalyzing this process is discussed. A powerful technique for the analysis of manganese redox changes in the water-oxidizing mechanism is the measurement of ultraviolet absorbance changes, induced by single-turnover light flashes on dark-adapted PS II preparations. Various interpretations of these ultraviolet absorbance changes have been proposed. Here it is shown that these changes are due to a single spectral component, which presumably is caused by the oxidation of Mn(III) to Mn(IV), and which oscillates with a sequence +1, +1, +1, -3 during the so-called S0----S1----S2----S3----S0 redox transitions of the oxygen-evolving complex. This interpretation seems to be consistent with the results obtained with other techniques, such as those on the multiline EPR signal, the intervalence Mn(III)-Mn(IV) transition in the infrared, and EXAFS studies. The dark distribution of the S states and its modification by high pH and by the addition of low concentrations of certain water analogues are discussed. Finally, the patterns of proton release and of electrochromic absorbance changes, possibly reflecting the change of charge in the oxygen-evolving system, are discussed. It is concluded that nonstoichiometric patterns must be considered, and that the net electrical charge of the system probably is the highest in state S2 and the lowest in state S1.
本文概述了光系统II供体侧的二次电子转移,在此过程中最终两个水分子被氧化成分子氧,并讨论了锰在催化这一过程中的核心作用。一种用于分析水氧化机制中锰氧化还原变化的强大技术是测量紫外吸收变化,该变化由暗适应的PS II制剂上的单周转光闪光诱导产生。对于这些紫外吸收变化已经提出了各种解释。本文表明,这些变化是由单一光谱成分引起的,这可能是由Mn(III)氧化为Mn(IV)所致,并且在所谓的放氧复合体的S0→S1→S2→S3→S0氧化还原转变过程中以+1、+1、+1、-3的顺序振荡。这种解释似乎与其他技术获得的结果一致,例如多线EPR信号、红外波段的Mn(III)-Mn(IV)价间跃迁以及EXAFS研究的结果。讨论了S态的暗分布及其在高pH值和添加低浓度某些水类似物时的变化。最后,讨论了质子释放模式和电致变色吸收变化模式,它们可能反映了放氧系统中的电荷变化。得出的结论是,必须考虑非化学计量模式,并且该系统的净电荷可能在S2态时最高,在S1态时最低。