Modeling uranium and Ra mobility during and after an acidic in situ recovery test (Dulaan Uul, Mongolia).

This article presents the results of groundwater monitoring over a period of six years and the interpretation of these results by a reactive transport model, following an In Situ Recovery (ISR) test on the Dulaan Uul uranium deposit in Mongolia. An environmental monitoring survey was set up using 17 piezometers, from which it has been possible to describe the changes in the water composition before, during and after the ISR test. The water quality before the start of mining activities rendered it unfit for human consumption. During and after the test, a descent of the saline plume was observed, resulting in a dilution of the injection solutions. After a rapid decrease to pH = 1.13 during the production phase of the ISR test, the pH stabilized at around 4 in the production area and 5.5 below the production cell one year after the end of the test. Uranium and radium were being naturally attenuated. Uranium returned to background concentrations (0.3 mg/L) after two years and the measured Ra concentrations represent no more than 10% of the expected concentrations during production (75 Bq/L). The modeling of the contaminants of concern mobility, namely pH and concentrations of sulfate, uranium and Ra, is based on several key complementary mechanisms: density flow, cation exchange with clay minerals and co-precipitation of Ra in the barite. The modeling results show that the observed plume descent and sulfate dilution can only be predicted if consideration of a high-density flow is included. Similarly, the changes in pH and Ra concentration are only correctly predicted when the cationic exchanges with the clays and the co-precipitation reaction within the barite using the solid solution theory are integrated into the models. Finally, the proper representation of the changes in water composition at the scale of the test requires the use of a sufficiently fine mesh (1 m × 1 m cell) to take into account the spatial variability of hydrogeological (permeability distribution in particular) and geological (reduced, oxidized and mineralized facies distributions) parameters.