Suppr超能文献

大转子内侧突出在骨水泥型髋关节置换术中会影响股骨柄位置吗?一项回顾性影像学研究。

Does Medial Overhang of the Greater Trochanter Influence Femoral Stem Position During Cemented Hip Arthroplasty? A Retrospective Radiological Review.

作者信息

Bayley Morgan, Cnudde Peter, Adds Phillip J, Jones Stephen, Williams Rhodri L

机构信息

Orthopaedics, Cardiff & Vale University Health Board, Cardiff, GBR.

Orthopaedics and Trauma, Hywel Dda University Health Board, Carmarthen, GBR.

出版信息

Cureus. 2020 Oct 15;12(10):e10968. doi: 10.7759/cureus.10968.

Abstract

Purpose We investigate the effect that variation in the anatomy of the greater trochanter (GT), in particular the medial overhang, can have on femoral stem alignment in total hip arthroplasty (THA). Methods Pre- and post-operative anteroposterior pelvic radiographs of 576 consecutive patients undergoing THA were retrospectively analysed. Medial overhang of the GT relative to the lateral femur diaphysis was measured. The femoral morphology was classified according to Dorr classification. The alignment of the femoral stem axes on post-operative radiographs was recorded. Results Following exclusions, 500 THAs performed by six surgeons all using the same cemented polish tapered stems were analysed: 320 THAs were performed via the posterior-lateral approach and 180 via the direct-lateral approach. Mean stem varus was 0.53° (range: -7 to 7°). Mean medial overhang was 21 mm (range: 8-43 mm). An overhang of <20 mm had a mean varus of -0.1°, an overhang of 20-30 mm had a mean varus of 0.8° and an overhang of >30 mm had a mean varus of 2.33°. Those with an overhang of <20 mm had a 2% chance of significant varus (≥4°), increasing to 9.5% for 20-30 mm and 44.4% for >30 mm. One-way analysis of variance comparison of these groups returned a p-value of <0.0001. Dorr type A femora had a mean varus of 0.52°, Dorr B had a mean varus of 0.54° and Dorr C had a mean varus of 0.46°. The posterior-lateral approach had a mean varus of 1.05° (range: -7 to 7°) compared to -0.40° (range: -5 to 5°) for direct-lateral approach. The t-test comparing approach was p < 0.0001. Discussion The extent of medial overhang of the GT can adversely affect the final stem position in THA, resulting in a statistically significant increase in mean stem varus. There is a linear relationship between stem position and GT overhang, with an increased chance of significant varus malposition (44.4% with >30 mm of overhang). Conclusions Scrutiny of pre-operative radiographs to determine high-risk patients is important, and we propose a classification system of GT anatomy to aid assessment.

摘要

目的 我们研究大转子(GT)解剖结构的变异,尤其是内侧悬垂,对全髋关节置换术(THA)中股骨柄对线的影响。方法 回顾性分析576例连续接受THA患者的术前和术后骨盆前后位X线片。测量GT相对于股骨外侧骨干的内侧悬垂。根据Dorr分类对股骨形态进行分类。记录术后X线片上股骨柄轴线的对线情况。结果 排除后,分析了由六位外科医生进行的500例THA,均使用相同的骨水泥抛光锥形柄:320例THA通过后外侧入路进行,180例通过直接外侧入路进行。平均柄内翻角度为0.53°(范围:-7至7°)。平均内侧悬垂为21mm(范围:8 - 43mm)。悬垂<20mm时平均内翻为-0.1°,20 - 30mm时平均内翻为0.8°,>30mm时平均内翻为2.33°。悬垂<20mm的患者出现明显内翻(≥4°)的几率为2%,20 - 30mm时增加到9.5%,>30mm时为44.4%。对这些组进行方差分析比较,p值<0.0001。Dorr A型股骨平均内翻为0.52°,Dorr B型为0.54°,Dorr C型为0.46°。后外侧入路平均内翻为1.05°(范围:-7至7°),而直接外侧入路为-0.40°(范围:-5至5°)。比较入路的t检验p<0.0001。讨论 GT的内侧悬垂程度会对THA中最终柄的位置产生不利影响,导致平均柄内翻在统计学上显著增加。柄位置与GT悬垂之间存在线性关系,明显内翻错位的几率增加(悬垂>30mm时为44.4%)。结论 术前仔细查看X线片以确定高危患者很重要,我们提出一种GT解剖分类系统以辅助评估。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/4165/7667602/481bc182bda8/cureus-0012-00000010968-i01.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验