Water Research Center, Kuwait Institute for Scientific Research, Kuwait City, Kuwait.
Arch Environ Contam Toxicol. 2021 Feb;80(2):331-349. doi: 10.1007/s00244-020-00787-y. Epub 2020 Nov 27.
Climate change in Kuwait has resulted in temperature fluctuations, frequent dust storms, and noticeable changes in the amount of precipitation. Pollutants released into the atmosphere from various sources affect the chemical composition of rainwater and impact its usability. The present study on rainwater focused on the determination of trace elements, sources, and their variation with respect to change in temperature and pH. The samples were collected from 12 different locations in both industrial and urban regions during significant rain events (n = 31) from November 2018 to March 2019 and samples were analyzed for trace elements in ICP-OES using standard USEPA 200.7 method. The mean concentration of the 16 elements analyzed followed the trend: Co < Cd < Cr < Mo < V<Ni < Pb < As < Se < Fe < Cu < Mn < Zn < Al < Ba < Sr and were inferred to be within the WHO permissible limits of drinking water. The analytical results revealed that Strontium (Sr) had the highest mean concentration (188 μg/L) followed by barium (Ba), aluminum (Al), and zinc (Zn) with mean concentrations of 95.2 μg/L, 30.4 μg/L, and, 16.6 μg/L respectively. The sources of contamination in rainwater were identified by calculating the enrichment factor (EF) using element concentration reported in Kuwait dust and from continental crustal values. EF for Fe, V, Ni, and Cr were below 10, indicating purely crustal sources. Ni, Zn, Cu, and Mn exhibited values between 10 and 100, reflecting industrial sources of contamination. EF for Sr was greater than 100, due to inputs from anthropogenic sources. A strong association between Al and pH along with correlation between Sr, Cr, Cu, Ni, Mo, V, and meteorological parameters was revealed from statistical analysis. Furthermore, pH Redox Equilibrium C programming (PHREEQC) was used to simulate changes in pH and temperature in rainwater to predict the resultant variations in trace element concentrations. There was no significant change observed in pH with rise in temperature, but the concentration of trace elements varied with change in pH. The concentration of V, Cr, and Al were most sensitive to pH variations. The results indicated that industrial emissions, fuel combustion, and dust in Kuwait are the primary sources of Al, Sr, Mn, Zn, and Ba in the rainwater samples. Since, the concentrations of these elements are relatively low, rainwater in Kuwait could be harvested for drinking and domestic purposes and used for recharging aquifers.
科威特的气候变化导致了温度波动、频繁的沙尘暴以及降水量的明显变化。各种来源排放到大气中的污染物会影响雨水的化学成分,并影响其可用性。本研究关注于雨水的微量元素含量、来源及其与温度和 pH 值变化的关系。在 2018 年 11 月至 2019 年 3 月的重大降雨事件期间,从工业和城市地区的 12 个不同地点采集了 31 个样本,并使用标准的美国环保署 200.7 方法通过电感耦合等离子体发射光谱仪 (ICP-OES) 对微量元素进行分析。分析的 16 种元素的平均浓度趋势为:Co < Cd < Cr < Mo < V < Ni < Pb < As < Se < Fe < Cu < Mn < Zn < Al < Ba < Sr,均在世界卫生组织饮用水允许限量范围内。分析结果表明,锶(Sr)的平均浓度最高(188μg/L),其次是钡(Ba)、铝(Al)和锌(Zn),其平均浓度分别为 95.2μg/L、30.4μg/L 和 16.6μg/L。通过使用科威特尘埃和大陆地壳值报告的元素浓度计算富集因子(EF),确定了雨水污染的来源。Fe、V、Ni 和 Cr 的 EF 值低于 10,表明其为纯粹的地壳来源。Ni、Zn、Cu 和 Mn 的 EF 值在 10 到 100 之间,表明存在工业污染来源。由于人为源的输入,Sr 的 EF 值大于 100。从统计分析中可知,Al 与 pH 之间存在强烈的相关性,以及 Sr、Cr、Cu、Ni、Mo、V 和气象参数之间的相关性。此外,还使用 PHREEQC 程序来模拟雨水的 pH 值和温度变化,以预测微量元素浓度的变化。随着温度的升高,pH 值没有明显变化,但微量元素的浓度随 pH 值的变化而变化。V、Cr 和 Al 的浓度对 pH 变化最为敏感。结果表明,科威特的工业排放、燃料燃烧和尘埃是雨水样品中 Al、Sr、Mn、Zn 和 Ba 的主要来源。由于这些元素的浓度相对较低,科威特的雨水可以用于饮用和家庭用途,并用于补给含水层。