Bärmann Peer, Krueger Bastian, Casino Simone, Winter Martin, Placke Tobias, Wittstock Gunther
Institute of Physical Chemistry, University of Münster, MEET Battery Research Center, Corrensstr. 46, 48149 Münster, Germany.
School of Mathematics and Sciences, Chemistry Department, Carl von Ossietzky University of Oldenburg, D-26111 Oldenburg, Germany.
ACS Appl Mater Interfaces. 2020 Dec 16;12(50):55903-55912. doi: 10.1021/acsami.0c16742. Epub 2020 Dec 1.
Because of their high specific capacity and rather low operating potential, silicon-based negative electrode materials for lithium-ion batteries have been the subject of extensive research over the past 2 decades. Although the understanding of the (de)lithiation behavior of silicon has significantly increased, several major challenges have not been solved yet, hindering its broad commercial application. One major issue is the low initial Coulombic efficiency and the ever-present self-discharge of silicon electrodes. Self-discharge itself affects the long-term stability of electrochemical storage systems and, additionally, must be taken into consideration for inevitable prelithiation approaches. The impact of the crystalline LiSi phase is of great interest as the phase transformation between crystalline () and amorphous () phases not only increases the specific surface area but also causes huge polarization. Moreover, there is the possibility for electrochemical over-lithiation toward the LiSi phase because of the electron-deficient LiSi phase, which can be highly reactive toward the electrolyte. This poses the question about the impact of the -LiSi phase on the self-discharge behavior in comparison to its amorphous counterpart. Here, silicon thin films used as model electrodes are lithiated to cut-off potentials of 10 mV and 50 mV Li|Li ( and ) in order to systematically investigate their self-discharge mechanism open-circuit potential () measurements and to visualize the solid electrolyte interphase (SEI) growth by means of scanning electrochemical microscopy. We show that the -LiSi phase is formed for the electrode, while it is not found for the electrode. In turn, the electrode displays an almost linear self-discharge behavior, whereas the electrode reaches a plateau at 380 mV Li|Li, which is due to the phase transition from -LiSi to the -LiSi phase. At this plateau potential, the phase transformation at the Si|electrolyte interface results in an electronically more insulating and more uniform SEI ( electrode), while the electrode displays a less uniform SEI layer. In summary, the self-discharge mechanism of silicon electrodes and, hence, the irreversible decomposition of the electrolyte and the corresponding SEI formation process heavily depend on the structural nature of the underlying lithium-silicon phase.
由于其高比容量和相对较低的工作电位,锂离子电池的硅基负极材料在过去20年里一直是广泛研究的主题。尽管对硅的(脱)锂行为的理解有了显著提高,但几个主要挑战尚未解决,这阻碍了其广泛的商业应用。一个主要问题是硅电极的初始库仑效率低和持续存在的自放电现象。自放电本身会影响电化学存储系统的长期稳定性,此外,对于不可避免的预锂化方法也必须加以考虑。结晶LiSi相的影响备受关注,因为结晶()相和非晶()相之间的相变不仅增加了比表面积,还会导致巨大的极化。此外,由于缺电子的LiSi相,存在向LiSi相进行电化学过锂化的可能性,这对电解质可能具有高反应活性。这就引发了一个问题,即与非晶态相比,-LiSi相对自放电行为有何影响。在这里,用作模型电极的硅薄膜被锂化至相对于Li|Li为10 mV和50 mV的截止电位(和),以便系统地研究它们的自放电机制——通过开路电位()测量,并借助扫描电化学显微镜观察固体电解质界面(SEI)的生长。我们表明,电极形成了-LiSi相,而电极未发现该相。相应地,电极表现出几乎线性的自放电行为,而电极在相对于Li|Li为380 mV时达到一个平台,这是由于从-LiSi相向-LiSi相的相变所致。在这个平台电位下,Si|电解质界面处的相变导致形成电子绝缘性更强且更均匀的SEI(电极),而电极的SEI层则不太均匀。总之,硅电极的自放电机制,以及因此电解质的不可逆分解和相应的SEI形成过程,在很大程度上取决于底层锂硅相的结构性质。