Department of Orthopaedic Surgery, School of Medicine, Keio University, Tokyo, Japan.
Department of Orthopaedic Surgery, School of Medicine, International University of Health and Welfare, Tokyo, Japan.
J Orthop Sci. 2021 Nov;26(6):1008-1013. doi: 10.1016/j.jos.2020.10.016. Epub 2020 Dec 8.
Peripheral triangular fibrocartilage complex (TFCC) tears may induce instability of the distal radioulnar joint (DRUJ). In this biomechanical study, simulated peripheral tears of the TFCC were examined on the stability of the DRUJ. Restabilization effect of the DRUJ by ulnar shortening and direct repair of those injuries were sequentially examined.
The DRUJ stiffness was measured in intact, simulated two types of peripheral tears (ulnar and extended ulnodorsal) at three forearm positions: neutral, 60° pronation and 60° supination in 8 fresh frozen cadaver specimens. After the tears were sutured with stitches or after simulated ulnar shortening of 3 mm, the DRUJ stiffness was again measured.
The ulnar and ulnodorsal TFCC tears decreased the DRUJ stiffness significantly compared with the intact in all forearm positions. When ulnar shortening was done for the ulnar tear, the DRUJ stiffness increased significantly in the neutral and 60° pronated positions. When the ulnar TFCC tear was repaired, the DRUJ stiffness increased significantly in all forearm positions. DRUJ stiffness did not increase either with ulnar shortening or repair in ulnodorsal tear of the TFCC, however.
The simulated TFCC tears indicated significant loss of DRUJ stiffness. Direct repair or ulnar shortening was effective only on treatment of the ulnar tear of the TFCC in this study.
外周三角纤维软骨复合体(TFCC)撕裂可能导致下尺桡关节(DRUJ)不稳定。在这项生物力学研究中,我们检查了 TFCC 的外周撕裂对 DRUJ 稳定性的影响。我们依次检查了 DRUJ 的尺侧缩短和直接修复对这些损伤的稳定作用。
在 8 个新鲜冷冻尸体标本中,在中立位、60°旋前位和 60°旋后位这三个前臂位置下,测量完整、模拟两种外周撕裂(尺侧和尺侧背侧)的 DRUJ 刚度。在缝合撕裂部位或模拟 3mm 尺侧缩短后,再次测量 DRUJ 刚度。
与完整组相比,尺侧和尺侧背侧 TFCC 撕裂在所有前臂位置均显著降低了 DRUJ 刚度。当对尺侧撕裂进行尺侧缩短时,DRUJ 刚度在中立位和 60°旋前位显著增加。当修复尺侧 TFCC 撕裂时,DRUJ 刚度在所有前臂位置均显著增加。然而,对于 TFCC 的尺侧背侧撕裂,尺侧缩短或修复均不能增加 DRUJ 刚度。
模拟 TFCC 撕裂显著降低了 DRUJ 刚度。在这项研究中,直接修复或尺侧缩短仅对尺侧 TFCC 撕裂有效。