Jiangsu Key Laboratory of Anaerobic Biotechnology, School of Environmental and Civil Engineering, Jiangnan University, Wuxi 214122, PR China; Jiangsu Collaborative Innovation Center of Technology and Material of Water Treatment, Suzhou 215011, PR China.
Jiangsu Key Laboratory of Anaerobic Biotechnology, School of Environmental and Civil Engineering, Jiangnan University, Wuxi 214122, PR China.
Waste Manag. 2021 Feb 15;121:1-10. doi: 10.1016/j.wasman.2020.11.054. Epub 2020 Dec 17.
Anaerobic digestion is a feasible and promising technique to deal with emerging waste activated sludge issues. In this work, the hydrodynamics and digestion performance of horizontal anaerobic systems equipped with double-bladed impeller and ribbon impeller were investigated. Simulation using computational fluid dynamics technique visually showcased the favorable mixing status implementing ribbon impeller. The mixing modes were considered as the major motivation for the difference of mixing efficiencies. Tracing experiment indicated that the minimum thorough mixing time with ribbon impeller was 20 min at a rotation speed of 50 rpm, whereas it was 360 min for the double-bladed impeller under similar conditions. The superior mixing performance of ribbon impeller resulted in better anaerobic digestion and energy efficiency outputs. The digester employing ribbon impeller obtained an ultimate biogas yield of 340.38 ± 15.91 mL/g VS (corresponding methane yield of 210.34 ± 7.55 mL/g VS) and produced a surplus energy of 16.23 ± 0.76 MJ/(m·d). This study thus ascertained that ribbon impeller was proficient for high-solid anaerobic digestion and it will prominently benefit future system designs.
厌氧消化是一种可行且有前途的技术,可以解决新兴的废活性污泥问题。在这项工作中,研究了配备双桨叶和带式搅拌器的水平厌氧系统的流体动力学和消化性能。使用计算流体动力学技术进行模拟,直观地展示了带式搅拌器实现良好混合状态的情况。混合模式被认为是混合效率差异的主要原因。示踪实验表明,在 50rpm 的转速下,带式搅拌器的最小充分混合时间为 20min,而在类似条件下,双桨叶的最小充分混合时间为 360min。带式搅拌器优越的混合性能导致更好的厌氧消化和能量效率输出。采用带式搅拌器的消化器最终获得了 340.38±15.91mL/gVS 的沼气产量(相应的甲烷产量为 210.34±7.55mL/gVS),并产生了 16.23±0.76MJ/(m·d)的剩余能量。因此,本研究确定带式搅拌器适用于高固体厌氧消化,它将显著有利于未来的系统设计。