Department of Energy Saving and Air Protection, Central Mining Institute, Plac Gwarków 1, 40-166, Katowice, Poland.
Institute of Chemical Process Fundamentals CAS, Vvi, Rozvojova 135, CZ-16502 Prague, Czech Republic.
Ecotoxicol Environ Saf. 2021 Jan 15;208:111710. doi: 10.1016/j.ecoenv.2020.111710. Epub 2020 Nov 26.
The aim of the study was to investigate the sorption interactions between phenol and materials obtained from four different underground coal gasification (UCG) ex-situ simulations. These interactions are significant in terms of the impact of the UCG on the groundwater environment. Sorption parameters were determined for two sample types: raw coal mined from the coal-bed and then subjected to the gasification process; and char residue acquired from the cavity formed as a result of the UCG processes. Laboratory-scale tests were carried out using deionized water and aqueous solutions with increasing concentrations of phenol (from 50 mg/dm to 2000 mg/dm) at 298 K. On the assumption of physical interactions (non-specific physisorption) and due to a nonlinear mass distribution of adsorbed substances as a function of equilibrium concentration, the Freundlich isotherm model was applied to describe adsorption phenomena. The isotherms have good fitting (R from 0.5716 to 0.9811). Relatively high percentage phenol removal efficiency was observed for all tested chars (from 17.0% to 99.8% for the 1.0-2.5 mm fraction and from 6.9% to 99.6% for the 10.0-12.5 mm fraction). Additionally, the sorption characteristics was used to evaluate the retardation coefficients. The largest delay in the organic pollutant migration in the environment around a UCG reactor occurs for phenol transport in the layer of the post-process char from 'Wesoła' after 40 bar pressure experiment.
本研究旨在探究酚与四种不同地下煤气化(UCG)原位模拟产物之间的吸附相互作用。这些相互作用对于 UCG 对地下水环境的影响具有重要意义。针对两种样品类型确定了吸附参数:一是从煤层中开采出来后经历气化过程的原煤;二是由于 UCG 过程而形成的腔室中获得的炭残留物。在 298 K 下,使用去离子水和含酚浓度逐渐增加的水溶液(从 50 mg/dm 至 2000 mg/dm)进行了实验室规模的测试。基于物理相互作用(非特异性物理吸附)和吸附物质平衡浓度的非线性质量分布假设,应用 Freundlich 等温线模型来描述吸附现象。这些等温线拟合度良好(R 值从 0.5716 到 0.9811)。所有测试的炭均表现出较高的去除效率(对于 1.0-2.5mm 粒径范围,去除效率为 17.0%至 99.8%;对于 10.0-12.5mm 粒径范围,去除效率为 6.9%至 99.6%)。此外,还利用吸附特性来评估阻滞系数。在经历 40 巴压力实验后,“Wesoła”后处理炭层中酚的迁移,其有机污染物在 UCG 反应器周围环境中的迁移延迟最大。