School of Chemical Engineering and Technology, Tianjin University, Tianjin, China.
College of Food Science and Biotechnology, Tianjin Agricultural University, Tianjin, China.
J Sci Food Agric. 2021 Aug 15;101(10):4350-4360. doi: 10.1002/jsfa.11075. Epub 2021 Feb 4.
Melt crystallization is typically recognized as a highly efficient and green method for oil fractionation. This work concentrated on novel layer melt crystallization for preparing desirable olein and stearin products from palm oil and the evaluation of fraction quality. Layer melt crystallization was performed at various temperatures and the effects on fractions were evaluated using iodine value (IV), solid fat content (SFC) and melting point. The lipid composition, thermal and crystallization properties, and phase behaviors of the final optimized fractions were determined using gas chromatography, high-performance liquid chromatography-atmospheric pressure chemical ionization mass spectrometry and differential scanning calorimetry.
Increasing crystallization tube temperatures under the same jacket temperature increased the melting point and SFC, while decreasing the IV of the olein product. Opposite results were observed for the stearin product. Major fatty acids in fractions were determined as palmitic acid and oleic acid. 1,2-Dioleoyl-3-palmitoylglycerol and 1,3-dipalmitoyl-2-oleoylglycerol were identified as the main triacylglycerols in olein and stearin fractions, respectively. A critical effect of crystallization temperature on co-crystallization of oleins and stearins was revealed. A transition from plate-like crystal growth to spherulitic growth with spontaneous nucleation was indicated in palm oil and stearin fractions with increasing crystallization temperature. As for olein fractions, a temperature increase resulted in heterogeneous nucleation from instantaneous nucleation.
Novel layer melt crystallization was successfully applied and optimized for fractionating palm oil. The composition and property changes of obtained fractions were analyzed and explained at both macroscopic and microscopic levels. © 2021 Society of Chemical Industry.
熔融结晶通常被认为是一种高效、绿色的油脂分提方法。本工作集中研究了新型层熔融结晶法,从棕榈油中制备所需的高油酸和高硬脂酸产品,并评价分提油的质量。在不同温度下进行层熔融结晶,采用碘值(IV)、固脂含量(SFC)和熔点评价各馏分的效果。采用气相色谱、高效液相色谱-大气压化学电离质谱和差示扫描量热法测定最终优化馏分的脂质组成、热和结晶性能以及相行为。
在相同夹套温度下提高结晶管温度,会提高高油酸产品的熔点和 SFC,降低 IV;而对高硬脂酸产品则相反。各馏分的主要脂肪酸为棕榈酸和油酸。高油酸和高硬脂酸馏分中的主要三酰基甘油分别为 1,2-二油酰基-3-棕榈酰甘油和 1,3-二棕榈酰基-2-油酰甘油。揭示了结晶温度对高油酸和高硬脂酸共结晶的重要影响。随着结晶温度的升高,棕榈油和高硬脂酸馏分的晶体生长从板状向球晶生长转变,呈自发成核。对于高油酸馏分,温度升高导致瞬时成核的异相成核。
成功应用并优化了新型层熔融结晶法对棕榈油进行分提。从宏观和微观两个层面分析并解释了所得馏分的组成和性质变化。 © 2021 化学工业协会。