Higashino Makoto, Aso Daiki, Stefan Heinz G
Dept. of Civil and Environmental Engineering, National Institute of Technology, Oita College, 1666 Maki, Oita, 870-0152, Japan.
Department of Molecular and Material Sciences, Interdisciplinary Graduate School of Engineering Sciences, Kyushu University, 6-1 Kasuga-Park, Fukuoka, 816-8580, Japan.
Environ Sci Pollut Res Int. 2021 May;28(18):22693-22704. doi: 10.1007/s11356-020-11730-y. Epub 2021 Jan 10.
Saturated/unsaturated pore water flow induced by rainwater infiltration in a soil column composed of a mixture of Toyoura sand and a small amount of clay (kaolin minerals) and the rinsing rate (mass transfer) of dissolved NaCl accumulated in the pore system from previous road salt application were investigated by experiments and simulations. Experiments were conducted with variable kaolin minerals mass contents (mixing ratios) in the soil columns. Measured saturated hydraulic conductivity (K) diminished with increased clay contents, i.e., K=0.00771, 0.00560, 0.00536, 0.00519, and 0.00314 cm s, for clay contents = 0.2, 0.5, 1, 2, and 5%, respectively. Experimental NaCl concentrations in the effluent from the bottom of the soil columns were about constant for times t ≈ 800, 1200, 1300, 1400, and 3400 s from the beginning of a rinsing experiment for the clay contents = 0.2, 0.5, 1, 2, and 5%, respectively. These NaCl concentrations then decreased with time quickly, and finally, approached zero. The presented model can reproduce experimental time variations of NaCl concentration in the effluent from the soil column reliably. Simulated salt mass left in the soil column with time also matches the experimental results for the clay contents = 0.2 and 0.5%. An inconsistency between simulated and experimental salt mass left in the soil columns becomes more significant as the clay content increases. These results suggest that the soil-water retention curve for the pure Toyoura sand can be applied to the soil column composed of kaolin minerals/Toyoura sand mixture when the clay content is small, i.e., less than 1%. Prediction of rinsing process becomes more difficult with increased clay content. However, the time required to remove saline water from the soil column to less than 1% of its initial value simulated by the model agrees closely with experimental results of 1000, 1500, 1700, 2100, and 5400 s, respectively.
通过实验和模拟,研究了在由丰浦砂和少量粘土(高岭土矿物)组成的土柱中,雨水入渗引起的饱和/非饱和孔隙水流动,以及先前道路撒盐后孔隙系统中积累的溶解氯化钠的冲洗速率(传质)。在土柱中以可变的高岭土矿物质量含量(混合比)进行实验。测得的饱和导水率(K)随粘土含量增加而降低,即粘土含量分别为0.2%、0.5%、1%、2%和5%时,K分别为0.00771、0.00560、0.00536、0.00519和0.00314 cm/s。对于粘土含量分别为0.2%、0.5%、1%、2%和5%的情况,从冲洗实验开始起,在t≈800、1200、1300、1400和3400 s时,土柱底部流出液中的实验氯化钠浓度大致恒定。然后这些氯化钠浓度随时间迅速降低,最终接近零。所提出的模型能够可靠地再现土柱流出液中氯化钠浓度的实验时间变化。模拟的土柱中随时间剩余的盐质量也与粘土含量为0.2%和0.5%时的实验结果相符。随着粘土含量增加,模拟和实验中土柱中剩余盐质量之间的不一致变得更加显著。这些结果表明,当粘土含量较小时,即小于1%时,纯丰浦砂的土壤水分保持曲线可应用于由高岭土矿物/丰浦砂混合物组成的土柱。随着粘土含量增加,冲洗过程的预测变得更加困难。然而,模型模拟的将土柱中的盐水去除至初始值的1%以下所需的时间分别与1000、1500、1700、2100和5400 s的实验结果非常吻合。