Fibula Jaw-in-a-Day with Minimal Computer-Aided Design and Manufacturing: Maximizing Efficiency, Cost-Effectiveness, Intraoperative Flexibility, and Quality.

The vascularized fibular flap has been the mainstay for mandibular reconstruction for over 30 years. Its latest evolutionary step is the jaw-in-a-day operation, during which the fibula flap and dental prosthesis restoration are performed in a single stage. Computer-aided design and manufacturing technology in mandibular reconstruction has gained popularity, as it simplifies the procedure and produces excellent outcomes. However, it is costly, time-consuming, and limited in cases that involve complex defects, including bone and soft-tissue coverage. Moreover, it does not allow for intraoperative changes in the surgical plan, including defect size and recipient vessel selection.The authors describe their approach, including a conventional technique for fibula osteoseptocutaneous flap harvest without the need for a premanufactured cutting guide, using bundled wooden tongue spatulas instead, a stereolithographic model to customize commercially ready-made reconstruction plates, and two pieces of resin to maintain occlusive alignment of the remaining jaw segments during mandibular osteotomy. Dental implants are inserted free-hand. Vector guides are then connected to the implants following insertion into the fibula to confirm acceptable alignment and subsequently replaced with scan sensors. An intraoperative digital scan is used to design and to produce a dental prosthesis by in-house milling of a polymethylmethacrylate block. From our 10-case experience over the past 3 years, we have found that our approach offers a reliable method that matches the excellent outcomes seen using full computer-assisted design and manufacturing technology. It is time- and cost-effective, not limited to relatively simple jaw defects, and can readily accommodate intraoperative changes of surgical plan.