Suppr超能文献

采用硫酸浸出法研究了焚烧对电动汽车锂离子电池湿法冶金回收中金属浸出率的影响。

Hydrometallurgical recycling of EV lithium-ion batteries: Effects of incineration on the leaching efficiency of metals using sulfuric acid.

机构信息

Department of Chemistry and Chemical Engineering, Industrial Materials Recycling and Nuclear Chemistry, Chalmers University of Technology, Chalmers University of Technology, SE-41296 Gothenburg, Sweden.

R&D Department, Envirobat España S.L., Avda. Lyon, 10, Azuqueca de Henares, 19200 Guadalajara, Spain.

出版信息

Waste Manag. 2021 Apr 15;125:192-203. doi: 10.1016/j.wasman.2021.02.039. Epub 2021 Mar 8.

Abstract

The growing demand for lithium-ion batteries will result in an increasing flow of spent batteries, which must be recycled to prevent environmental and health problems, while helping to mitigate the raw materials dependence and risks of shortage and promoting a circular economy. Combining pyrometallurgical and hydrometallurgical recycling approaches has been the focus of recent studies, since it can bring many advantages. In this work, the effects of incineration on the leaching efficiency of metals from EV LIBs were evaluated. The thermal process was applied as a pre-treatment for the electrode material, aiming for carbothermic reduction of the valuable metals by the graphite contained in the waste. Leaching efficiencies above 70% were obtained for Li, Mn, Ni and Co after 60 min of leaching even when using 0.5 M sulfuric acid, which can be linked to the formation of more easily leachable compounds during the incineration process. When the incineration temperature was increased (600-700 °C), the intensity of graphite signals decreased and other oxides were identified, possibly due to the increase in oxidative conditions. Higher leaching efficiencies of Mn, Ni, Co, and Li were reached at lower temperatures of incineration (400-500 °C) and at higher leaching times, which could be related to the partial carbothermic reduction of the metals.

摘要

对锂离子电池的需求不断增长,将导致废旧电池的数量不断增加,必须对其进行回收,以防止出现环境和健康问题,同时有助于缓解对原材料的依赖以及短缺和促进循环经济的风险。最近的研究重点是结合火法冶金和湿法冶金回收方法,因为它可以带来许多优势。在这项工作中,评估了焚烧对从电动汽车 LIB 中浸出金属的浸出效率的影响。热过程被用作电极材料的预处理,目的是通过废物中含有的石墨对有价值的金属进行碳热还原。即使使用 0.5 M 硫酸,在浸出 60 分钟后,Li、Mn、Ni 和 Co 的浸出率仍超过 70%,这可能与焚烧过程中形成更易浸出的化合物有关。当焚烧温度升高(600-700°C)时,石墨信号的强度降低,并且鉴定出其他氧化物,这可能是由于氧化条件增加所致。在较低的焚烧温度(400-500°C)和较高的浸出时间下,Mn、Ni、Co 和 Li 的浸出效率更高,这可能与金属的部分碳热还原有关。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验