Development of layer-by-layer assembled polyamide-imide membranes for oil sands produced water treatment.

The sustainable expansion of steam-assisted gravity drainage, as one of the most popular enhanced oil recovery methods, strongly depends on the proper management of the produced water. The strict environmental regulations have forced the oil sands industry to treat and reuse the produced water for oil extraction. Membrane separation as a single-step water treatment technique has played an important role in removing multiple-sized contaminants from wastewater. However, fouling limits the widespread application of this technology if the membrane is not modified properly to achieve antifouling propensities. Herein, we used the layer-by-layer assembly technique to sequentially coat the hydrophilic poly(diallyl dimethylammonium chloride) and polyacrylic acid on the surface of the polyamide-imide porous membrane to improve its fouling resistance. The effect of the number of bilayers on fouling and permeation properties was examined. The membrane with the highest fouling resistance and reasonable hydrodynamic permeability of 5.2 LMH/psi was achieved by coating four bilayers. This membrane exhibited a low flux decline of 50.2% and a high flux recovery ratio of 100%, while these numbers for the pristine PAI membrane were 75.9% and 97.8% under similar test conditions. The enhanced antifouling characteristics of the modified membranes indicate the viability of these membranes for oil sands produced water treatment with an easy cleaning procedure. The key parameter that contributed to the enhanced fouling resistance of the bilayer-coated membranes was the improved surface hydrophilicity, which manifests through the reduction of water contact angle from 62° ± 3° for the pristine membrane to 52° ± 2° for surface-modified membranes.