[Responses of photosynthesis and P/Fe traits to P application in soybean under stress of low Fe.].

We examined the effects of phosphorus (P) levels on photosynthetic and P/Fe traits of soybean under the stress of low Fe and their genotypic differences, to provide a theoretical basis for rational application of P and Fe fertilizer. Six P-efficient and six P-inefficient soybean varieties screened in the early stage were used as experimental materials. Four treatments of P:Fe ratio were set, including 0:30, 30:30, 150:30 and 300:30 (μmol·L). We measured chlorophyll fluorescence traits and P-Fe utilization efficiency in soybean. A stepwise regression equation was established with seed weight per plant. Pathway analysis was performed, with the response of P-efficient and P-inefficient soybean genotypes to different P:Fe treatments being comprehensively evaluated by factor scores. The results showed significant main and interactive effects of genotype and P:Fe on the relative electron transfer rate of photosystem Ⅱ (ETR) at beginning of flowering stage (R1), the proportion of the energy absorbed by photosystem Ⅱ dissipated into heat (NPQ) at R1 stage, and proportion of energy absorbed by photosystem Ⅱ devoted to the photochemical reaction (L) at R1 stage. Results of canonical correlation analysis showed a negative correlation between P utilization efficiency of seed at full maturity stage (R8) and photosynthetic rate at R1 stage of P-efficient genotypes. Seed Fe utilization efficiency of P-inefficient genotypes at R8 stage was positively correlated with NPQ at R1 stage, but negatively correlated with L at R1 stage. The actual photochemical efficiency of PSⅡ () at R1 stage was negatively correlated with P-efficient genotypes, but positively correlated with P-inefficient genotypes, which indicated that at R1 stage was an important indicator for identifying soybean genotypes with different P efficiency under stress of low Fe. The comprehensive performance of P-efficient soybean genotypes decreased first and then increased with P level, while P-inefficient soybean genotypes increased first and then decreased. The inflection point of both genotypes appeared in P:Fe of 30:30. Thus, P:Fe ratio of 30:30 could be used as a threshold to identify soybean genotypes with different P efficiency under stress of low Fe. In conclusion, P fertilizer application should be equal to or greater than 1:1 (P:Fe) when planting P-efficient soybean genotypes in low Fe area, while P fertilizer application should not exceed 1:1 (P:Fe) when planting P-inefficient soybean genotypes.