Suppr超能文献

[使用特殊类型的睾丸超声检查、普拉德睾丸测量器、席伦氏环和滑动卡尺对人类睾丸进行比较容积测量]

[Comparative volumetry of human testes using special types of testicular sonography, Prader's orchidometer, Schirren's circle and sliding caliber].

作者信息

Dörnberger V, Dörnberger G

机构信息

Medizinische Poliklinik der Medizinischen Universitätskliniken Tübingen.

出版信息

Andrologia. 1987 Sep-Oct;19(5):487-96.

PMID:3425952
Abstract

On 99 testes of corpses (death had occurred between 26 und 86 years) comparative volumetry was done. In the left surrounding capsules (without scrotal skin and tunica dartos) the testes were measured via real time sonography in a waterbath (7.5 MHz linear-scan), afterwards length, breadth and height were measured by a sliding calibre, the largest diameter (the length) of the testis was determined by Schirren's circle and finally the size of the testis was measured via Prader's orchidometer. After all the testes were surgically exposed, their volume (by litres) was determined according to Archimedes' principle. As for the Archimedes' principle a random mean error of 7% must be accepted, sonographic determination of the volume showed a random mean error of 15%. Whereas the accuracy of measurement increases with increasing volumes, both methods should be used with caution if the volumes are below 4 ml, since the possibilities of error are rather great. According to Prader's orchidometer the measured volumes on average were higher (+ 27%) with a random mean error of 19.5%. With Schirren's circle the obtained mean value was even higher (+ 52%) in comparison to the "real" volume by Archimedes' principle with a random mean error of 19%. The measurements of the testes in the left capsules by sliding calibre can be optimized, if one applies a correcting factor f (sliding calibre) = 0.39 for calculation of the testis volume corresponding to an ellipsoid. Here you will get the same mean value as in Archimedes' principle with a standard mean error of only 9%. If one applies the correction factor of real time sonography of testis f (sono) = 0.65 the mean value of sliding calibre measurements would be 68.8% too high with a standard mean error of 20.3%. For measurements via sliding calibre the calculation of the testis volume corresponding to an ellipsoid one should apply the smaller factor f (sliding calibre) = 0.39, because in this way the left capsules of testis and the epididymis are considered.

摘要

对99具尸体的睾丸(死者年龄在26至86岁之间)进行了体积比较测量。在左侧周围包膜(不包括阴囊皮肤和肉膜)中,通过水浴中的实时超声检查(7.5兆赫线阵探头)测量睾丸,之后用游标卡尺测量其长、宽和高,通过施伦圆确定睾丸的最大直径(长度),最后用普拉德睾丸计测量睾丸大小。所有睾丸经手术暴露后,根据阿基米德原理确定其体积(以升为单位)。对于阿基米德原理,必须接受7%的随机平均误差,超声测量体积的随机平均误差为15%。虽然测量精度会随着体积的增加而提高,但如果体积低于4毫升,两种方法都应谨慎使用,因为误差可能性相当大。根据普拉德睾丸计,测量的平均体积更高(+27%),随机平均误差为19.5%。与阿基米德原理得出的“实际”体积相比,用施伦圆得出的平均值更高(+52%),随机平均误差为19%。如果应用校正因子f(游标卡尺)=0.39来计算对应椭球体的睾丸体积,那么通过游标卡尺测量左侧包膜内睾丸的方法可以得到优化。这样得到的平均值与阿基米德原理相同,标准平均误差仅为9%。如果应用睾丸实时超声的校正因子f(超声)=0.65,游标卡尺测量值的平均值会高出68.8%,标准平均误差为20.3%。对于通过游标卡尺测量,计算对应椭球体的睾丸体积时应应用较小的因子f(游标卡尺)=0.39,因为这样可以考虑左侧睾丸包膜和附睾。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验