Afia Ramy S A, Mustafa Ehtasham, Tamus Zoltán Ádám
Department of Electrical Power & Machines Engineering, Faculty of Engineering, Helwan University, 1 Sherif Street, Helwan 11792, Egypt.
Department of Electric Power Engineering, Faculty of Electrical Engineering & Informatics, Budapest University of Technology & Economics, P.O. Box 91, H-1521 Budapest, Hungary.
Polymers (Basel). 2021 Sep 8;13(18):3033. doi: 10.3390/polym13183033.
Low-voltage cable systems in nuclear power plants are key components that have a crucial role in the safe operation of nuclear facilities. Thus, the aging management of cable systems is of utmost importance as they cannot easily or economically be replaced or upgraded. Therefore, there is a continuous need to develop reliable non-destructive condition monitoring techniques, mostly based on the measurement of the dielectric properties of cable insulation. This paper introduces the changing of dielectric and mechanical properties of XLPE insulated and CSPE jacketed unshielded low-voltage nuclear power plant power cable in case of simultaneous mechanical and radiation aging. The cable samples were bent and exposed to 400 kGy gamma irradiation with a 0.5 kGy/hr dose rate. Dielectric response (real and imaginary permittivity) in the 0.1 Hz-1 kHz frequency range, extended voltage response (EVR), and the Shore D hardness test techniques were measured to track aging. The electrical and mechanical parameters have increased monotonically with aging, except the imaginary permittivity, which increased only at frequencies higher than 10 Hz. Furthermore, different quantities were deducted based on the frequency and permittivity data. The electrical parameters and deducted quantities correlation with aging and mechanical parameters were investigated. Since the deducted quantities and the electrical parameters are strongly correlated with absorbed dose and mechanical properties, the electrical measurements can be applied as a non-destructive aging indicator for XLPE/CSPE unshielded low-voltage nuclear power cables.
核电站中的低压电缆系统是关键部件,在核设施的安全运行中起着至关重要的作用。因此,电缆系统的老化管理至关重要,因为它们不易或不经济地进行更换或升级。因此,持续需要开发可靠的无损状态监测技术,主要基于对电缆绝缘介电性能的测量。本文介绍了交联聚乙烯(XLPE)绝缘和氯化聚乙烯(CSPE)护套无屏蔽低压核电站电力电缆在机械老化和辐射老化同时发生的情况下,其介电性能和机械性能的变化。将电缆样品弯曲并以0.5 kGy/小时的剂量率暴露于400 kGy的伽马辐射下。测量了0.1 Hz至1 kHz频率范围内的介电响应(实介电常数和虚介电常数)、扩展电压响应(EVR)以及邵氏D硬度测试技术,以跟踪老化情况。除了虚介电常数仅在高于10 Hz的频率下增加外,电气和机械参数随老化单调增加。此外,根据频率和介电常数数据推导出不同的量。研究了电气参数和推导量与老化及机械参数的相关性。由于推导量和电气参数与吸收剂量和机械性能密切相关,电气测量可作为XLPE/CSPE无屏蔽低压核电电缆的无损老化指标。