Zanon Davide, Selmin Francesca, Centin Giorgio, Maximova Natalia, Casiraghi Antonella, Minghetti Paola
Department of Pharmacy and Clinical Pharmacology, Institute for Maternal and Child Health - IRCCS "Burlo Garofolo", Via dell'Istria 65/1, 34137 Trieste, Italy.
Department of Pharmaceutical Sciences, Università degli Studi di Milano, Via Giuseppe Colombo 71, 20133 Milan, Italy.
Eur J Pharm Sci. 2021 Dec 1;167:106039. doi: 10.1016/j.ejps.2021.106039. Epub 2021 Oct 10.
Stringent formulation requirements are defined to intrathecally administer drug substances, avoiding neurological complications. In case of pediatric patients, these are further complicated due to the limited volumes of the celebrospinal fluid and, therefore, high concentrated solutions of methotrexate (MTX), cytarabine and corticosteroids (i.e., methylprednisolone or hydrocortisone) are prepared based on the patient's age. This work aims to assess the chemical and physical stability of triple intrathecal mixtures differing in volume and composition by a bracketing approach and to identify possible stress causes and mitigation strategies. Low solubility of MTX was the main factor limiting the physical stability of triple mixtures. Regarding solutions containing methylprednisolone, the amount of MTX remaining was about 95% in the solution at highest concentrations with the concomitant formation of a visible particulate sizing bigger than 1 µm after 24 h of storage at 25 °C. This behavior was mainly driven by the pH reduction due to the pH value of the cytarabine solution used; the shear stress also induced drug precipitation. In the case of the hydrocortisone based mixtures, the precipitate formation occurred at a slow rate. To improve the physical stability, a better control of the mixture pH (optimal value ≈ 7) is required or, as an alternative, the addition of the cytarabine solution to a pre-mixed binary mixture containing MTX and a corticosteroid should be preferred.
为鞘内注射药物制定了严格的配方要求,以避免神经并发症。对于儿科患者,由于脑脊液量有限,情况更为复杂,因此,根据患者年龄制备高浓度的甲氨蝶呤(MTX)、阿糖胞苷和皮质类固醇(即甲泼尼龙或氢化可的松)溶液。本研究旨在通过括号法评估不同体积和组成的三联鞘内混合物的化学和物理稳定性,并确定可能的应力原因和缓解策略。MTX的低溶解度是限制三联混合物物理稳定性的主要因素。对于含有甲泼尼龙的溶液,在25℃储存24小时后,最高浓度溶液中剩余的MTX量约为95%,同时形成可见的大于1μm的颗粒。这种行为主要是由于所用阿糖胞苷溶液的pH值导致pH降低;剪切应力也会导致药物沉淀。对于基于氢化可的松的混合物,沉淀形成的速度较慢。为了提高物理稳定性,需要更好地控制混合物的pH值(最佳值≈7),或者作为一种替代方法,应优先将阿糖胞苷溶液添加到含有MTX和皮质类固醇的预混合二元混合物中。