Effect of pressure drop on the in vitro dispersion of adhesive mixtures of different blend states for inhalation.

In this study, the effect of pressure drop (ΔP) on the in vitro dispersion of a series of carrier-based adhesive mixtures of different fines-to-carrier proportions, corresponding to the four different blend states of the blend state model, i.e. S1 to S3, was investigated. Four binary and one ternary adhesive mixture consisting of lactose carrier and budesonide fines and lactose fines were prepared. The dispersion was assessed using a next generation impactor (NGI) at ΔP of 0.5, 2 and 4 kPa. For the S1 mixture, where the fines were located in surface cavities of the carrier, the fine particle fraction (FPF) increased nearly linearly with ΔP. For S2 and S3 mixtures, with adhesion layers on the enveloped carrier surface, the FPF-ΔP relationships were bended and approached a plateau. Examination of powder captured in the pre-separator of the NGI led to the conclusion that the dispersion of these adhesive mixtures occurred by erosion of the adhesion layer, i.e. budesonide was liberated as single particles or micro-agglomerates. It is concluded that the FPF-ΔP relationships were dependent on the blend state and for the S2 and S3 mixtures, a critical pressure drop was identified above which the pressure drop had a limited effect on the FPF.