Cedars-Sinai Kerlan-Jobe Institute, Los Angeles, California, USA.
Orthopaedic Biomechanics Laboratory, Cedars-Sinai Medical Center, Los Angeles, California, USA.
Am J Sports Med. 2022 Jul;50(9):2462-2468. doi: 10.1177/03635465221101126. Epub 2022 Jun 20.
Questions remain about whether circumferential labral reconstruction (CLR) using an iliotibial band (ITB) allograft can effectively restore the labral suction seal of the hip.
(1) CLR with an ITB allograft >6.5 mm would restore distractive stability force to that of the intact labrum. (2) CLR with an ITB allograft >6.5 mm would achieve significantly superior distractive stability force compared with CLR with an ITB allograft <6.5 mm.
Controlled laboratory study.
A total of 6 fresh-frozen pelves with attached femurs (n = 12 matched hemipelves) from male donors were procured and dissected free of all soft tissue, including the hip capsule but preserving the native labrum, transverse acetabular ligament, and ligamentum teres. Potted hemipelves were placed in a saline bath and securely fixed to the frame of a hydraulic testing system. A 500-N compressive load was applied, followed by femoral distraction at a rate of 5.0 mm/s until the suction seal ruptured. Force and femoral displacement were continually recorded. Force versus displacement curves were plotted, the maximum force was recorded, and the amount of femoral distraction to rupture the suction seal was determined. After intact testing, the labrum was excised, and specimens were retested using the same protocol. CLR was subsequently performed twice in a randomized fashion using (1) an ITB allograft with a width >6.5 mm (7.5-9.0 mm) and (2) an ITB allograft with a width <6.5 mm (4.5-6.0 mm). Specimens were retested after each CLR procedure. Force (in Newtons) and femoral distraction (in millimeters) required to rupture the suction seal were measured and compared between the 4 testing states (intact, deficient, CLR <6.5 mm, and CLR >6.5 mm) using repeated-measures analysis of variance.
On average, intact specimens required 148.4 ± 33.1 N of force to rupture the hip suction seal, which significantly decreased to 44.3 N in the deficient state ( < .001). CLR with ITB allografts <6.5 mm did not improve the maximum force (63 ± 62 N) from the deficient state ( = .42) and remained significantly lower than the intact state ( < .01). CLR with ITB allografts >6.5 mm recorded significantly greater force to rupture the suction seal (135.8 ± 44.6 N) compared with both the deficient and CLR <6.5 mm states ( < .01), with a mean force comparable with the intact labrum ( = .59). The amount of femoral distraction to rupture the suction seal demonstrated similar findings.
In a cadaveric model, CLR using ITB allografts >6.5 mm restored the distractive force and distance to the suction seal rupture to values comparable with hips with an intact labrum. CLR using ITB allografts >6.5 mm outperformed CLR with ITB allografts <6.5 mm, demonstrated by a significantly higher force to rupture the suction seal and increased distraction before the rupture.
The results of this cadaveric investigation suggest that using wider labral allografts during CLR will provide the distractive force required to rupture the suction seal and immediate postoperative stability of the hip, although further studies are required to determine if these results translate to improved clinical outcomes.
关于使用阔筋膜张肌腱(ITB)移植物进行环形盂唇重建(CLR)是否能有效恢复髋关节盂唇的抽吸密封,仍存在疑问。
(1)宽度>6.5 毫米的 CLR 用 ITB 移植物可恢复盂唇的分散稳定性力。(2)宽度>6.5 毫米的 CLR 用 ITB 移植物的分散稳定性力明显优于宽度<6.5 毫米的 CLR 用 ITB 移植物。
对照性实验室研究。
从男性供体中获得 6 个附有股骨的新鲜冷冻骨盆(n=12 个匹配的半骨盆),并将其从所有软组织中解剖出来,包括髋关节囊,但保留了固有盂唇、横髋臼韧带和圆韧带。将盆栽半骨盆置于盐水中,并牢固地固定在液压测试系统的框架上。施加 500-N 的压缩载荷,然后以 5.0 毫米/秒的速度对股骨进行分离,直到抽吸密封破裂。连续记录力和股骨位移。绘制力与位移曲线,记录最大力,并确定使抽吸密封破裂的股骨分离量。在完整测试后,切除盂唇,并使用相同的方案对相同的标本进行重复测试。随后以随机方式进行两次 CLR,使用(1)宽度>6.5 毫米(7.5-9.0 毫米)的 ITB 移植物和(2)宽度<6.5 毫米(4.5-6.0 毫米)的 ITB 移植物。每次 CLR 程序后,对标本进行重新测试。使用重复测量方差分析比较 4 种测试状态(完整、缺陷、CLR<6.5 毫米和 CLR>6.5 毫米)之间破裂抽吸密封所需的力(牛顿)和股骨分离(毫米)。
平均而言,完整标本需要 148.4±33.1 N 的力来破裂髋关节抽吸密封,在缺陷状态下,这一数值显著下降至 44.3 N(<0.001)。宽度<6.5 毫米的 CLR 用 ITB 移植物并没有改善从缺陷状态下获得的最大力(63±62 N)(=0.42),并且仍然明显低于完整状态(<0.01)。宽度>6.5 毫米的 CLR 用 ITB 移植物记录的破裂抽吸密封所需的力明显更大(135.8±44.6 N),与缺陷和 CLR<6.5 毫米状态相比(<0.01),与完整的盂唇相比,平均力相似(=0.59)。破裂抽吸密封所需的股骨分离量也得出了类似的结果。
在尸体模型中,使用宽度>6.5 毫米的 ITB 移植物进行 CLR 可恢复分散力和到抽吸密封破裂的距离,使其达到与具有完整盂唇的髋关节相当的值。使用宽度>6.5 毫米的 ITB 移植物进行 CLR 优于使用宽度<6.5 毫米的 ITB 移植物进行 CLR,这一点通过破裂抽吸密封所需的力明显更高和破裂前的分离力增加来证明。
这项尸体研究的结果表明,在 CLR 中使用更宽的盂唇移植物将提供破裂抽吸密封所需的分散力和髋关节的即时术后稳定性,尽管需要进一步的研究来确定这些结果是否转化为更好的临床结果。