Liu David W, Martinez Martos Sara, Dai Yifei, Beller Elaine M
Gold Coast Centre for Bone and Joint Surgery, 14 Sixth Avenue, Palm Beach, QLD, 4221, Australia.
Exactech Inc., 2320 NW 66th Ct., Gainesville, FL, 32653, USA.
Knee Surg Relat Res. 2022 Jul 7;34(1):32. doi: 10.1186/s43019-022-00159-x.
Conventionally, the depth of distal femoral resection in total knee arthroplasty is referenced from the most prominent distal femoral condyle. This surgical technique does not consider pathological alterations of articular surfaces or severity of knee deformity. It has been hypothesized that the femoral intercondylar notch is a clinically reliable and more accurate alternative landmark for the resection depth of the distal femur in primary total knee arthroplasty.
The resection depths of the distal femur at the medial and lateral femoral condyles and intercondylar notch were measured using computer navigation in 406 total knee arthroplasties. Variability between the bone resection depths was analyzed by standard deviation, 95% confidence interval and variance. Clinical follow-up of outcome to a minimum of 12 months was performed to further inform and validate the analysis.
Mean resection depth of the medial condyle was 10.7 mm, of the lateral condyle 7.9 mm and of the femoral intercondylar notch 1.9 mm. The femoral intercondylar notch had the lowest variance in resection depth among the three landmarks assessed, with a variance of 1.7 mm compared to 2.8 mm for the medial femoral condyle and 5.1 mm for the lateral femoral condyle. The intercondylar notch reference had the lowest standard deviation and 95% confidence interval. The resection depth referencing the notch was not sensitive to the degree of flexion contracture pre-operatively, whereas the medial and lateral condyles were. For varus deformed knees, distal femoral resection depth at the notch averaged 2 mm, which corresponds to the femoral prosthesis thickness at the intercondylar region, while for valgus deformed knees, the resection was flush with the intercondylar notch.
The femoral intercondylar notch is a clinically practical and reproducible landmark for appropriate and accurate resection depth of the distal femur in primary total knee arthroplasty.
Level III: Retrospective cohort study.
传统上,全膝关节置换术中股骨远端截骨的深度是参照股骨最突出的远端髁来确定的。这种手术技术没有考虑关节面的病理改变或膝关节畸形的严重程度。有假说认为,在初次全膝关节置换术中,股骨髁间切迹是用于确定股骨远端截骨深度的一种临床可靠且更准确的替代标志。
在406例全膝关节置换术中,使用计算机导航测量股骨内侧髁、外侧髁和髁间切迹处的股骨远端截骨深度。通过标准差、95%置信区间和方差分析骨截骨深度之间的变异性。进行至少12个月的临床结局随访,以进一步为分析提供信息并验证分析结果。
内侧髁的平均截骨深度为(10.7)毫米,外侧髁为(7.9)毫米,股骨髁间切迹为(1.9)毫米。在所评估的三个标志中,股骨髁间切迹的截骨深度方差最低,为(1.7)毫米,而股骨内侧髁为(2.8)毫米,股骨外侧髁为( 5.1)毫米。以髁间切迹为参考的截骨深度具有最低的标准差和95%置信区间。以髁间切迹为参考的截骨深度对术前屈曲挛缩程度不敏感,而内侧和外侧髁则敏感。对于内翻畸形膝关节,髁间切迹处的股骨远端截骨深度平均为(2)毫米,这与髁间区域的股骨假体厚度相对应,而对于外翻畸形膝关节,截骨与髁间切迹齐平。
在初次全膝关节置换术中,股骨髁间切迹是用于适当且准确地确定股骨远端截骨深度的临床实用且可重复的标志。
III级:回顾性队列研究。