Chiu Y C, Ballou E W, Ford L E
Circ Res. 1987 Mar;60(3):446-58. doi: 10.1161/01.res.60.3.446.
The instantaneous force-velocity relations of cat papillary muscles were studied at different times in the twitch in normal and in postextrasystolic potentiated contractions. Fourteen to sixteen different loads were used to define each of the force-velocity curves. The curves were fitted by a least-squares procedure to the hyperbolic (Hill equation). The hyperbolae were extrapolated to obtain maximum velocity and isometric force and interpolated to obtain maximum power. All three of these values rose more quickly than developed force. Maximum velocity reached 77% of its peak at the earliest time studied, 20-25% of the time to peak force. Developed force achieved 22% of its final value at this time, while extrapolated isometric force and maximum power both reached 44% of their peak values. Postextrasystolic potentiation sufficient to produce a 1.5 to twofold increase in peak developed force produced less than a 20% increase in extrapolated maximum velocity. The results can be interpreted in terms of a model in which the maximum velocity of the contractile elements remains constant during the twitch. Variation in maximum velocity is attributed to a small internal load, equivalent to 6% of twitch force. Since maximum velocity is relatively constant, it does not give a good measure of changes in the force-velocity curves. By contrast, the extrapolated isometric force and maximum power are much more sensitive to changes in the force-velocity curves, and they vary in proportion to each other. The advantage of using interpolated maximum power rather than isometric force to define changes in the curves is that it can be normalized to muscle mass.
在正常收缩和期外收缩后增强收缩的不同时刻,研究了猫乳头肌的瞬时力-速度关系。使用14至16种不同的负荷来定义每条力-速度曲线。通过最小二乘法将曲线拟合为双曲线(希尔方程)。将双曲线外推以获得最大速度和等长力,并进行内插以获得最大功率。这三个值的上升速度均比发展力快。在最早研究的时刻,最大速度达到其峰值的77%,即达到峰值力时间的20 - 25%。此时发展力达到其最终值的22%,而外推的等长力和最大功率均达到其峰值的44%。足以使峰值发展力增加1.5至两倍的期外收缩后增强,使外推的最大速度增加不到20%。结果可以用一个模型来解释,即收缩元件的最大速度在收缩过程中保持恒定。最大速度的变化归因于一个小的内部负荷,相当于收缩力的6%。由于最大速度相对恒定,它不能很好地衡量力-速度曲线的变化。相比之下,外推的等长力和最大功率对力-速度曲线的变化更为敏感,并且它们相互成比例变化。使用内插最大功率而不是等长力来定义曲线变化的优点是它可以归一化为肌肉质量。