Suppr超能文献

通过分子动力学模拟研究热重排的TR-PBO膜以及其6FDA-双APAF聚酰亚胺前体中N/CH的单气体和混合气体渗透情况。

Single-gas and mixed-gas permeation of N/CH in thermally-rearranged TR-PBO membranes and their 6FDA-bisAPAF polyimide precursor studied by molecular dynamics simulations.

作者信息

Tanis Ioannis, Brown David, Neyertz Sylvie, Vaidya Milind, Ballaguet Jean-Pierre, Duval Sebastien, Bahamdan Ahmad

机构信息

Univ. Grenoble Alpes, Univ. Savoie Mont Blanc, CNRS, Grenoble INP (Institute of Engineering and Management Univ. Grenoble Alpes), LEPMI, 38000 Grenoble, France.

Saudi Aramco, Research & Development Center, Po. Box 62, Dhahran 31311, Saudi Arabia.

出版信息

Phys Chem Chem Phys. 2022 Aug 10;24(31):18667-18683. doi: 10.1039/d1cp05511a.

Abstract

High-performance polymers with polybenzoxazole (PBO) structures, formed thermal rearrangement (TR) of aromatic polyimide precursors, have been developed for gas separation applications. The present work compares the transport of N and CH in a 6FDA-bisAPAF polyimide precursor and in its TR-PBO derivative using molecular dynamics (MD) simulations. The modelling closely mimicked the experimental approach by transforming a 6FDA-bisAPAF atomistic model into its corresponding TR-PBO structure a specific algorithm. The densities and void spaces of both precursor and TR polymers were found to compare well to experimental data. An iterative technique was used to obtain the single-gas sorption isotherms of N and CH at 338.5 K in both polymers over a range of feed pressures up to and exceeding 65 bar. CH was systematically found to be more soluble than N. Solubilities in both matrices were quite similar with those in TR-PBO being slightly higher due to its larger fraction of significant volume. Volume dilation analyses confirmed a higher resistance to plasticization for TR-PBO. Extended single-gas N and CH simulations and 2 : 1 binary CH/N mixed-gas simulations were then conducted in both matrices at 338.5 K and at a pressure of ∼65 bar corresponding to natural gas processing conditions. Mixed-gas sorption was modelled using a modification of the aforementioned iterative method, which fixed the pressure and iterated to convergence the number of molecules of each type of penetrant. The gas diffusion coefficients were estimated using the Trajectory-Extending Kinetic Monte Carlo (TEKMC) procedure. As found experimentally, significantly higher diffusivities and permeabilities were observed in the TR polymer, which led to a slightly lower ideal N/CH permselectivity for TR-PBO (∼2.6) when compared to its 6FDA-bisAPAF precursor (∼3.8). However, both models showed a reduced N/CH separation efficiency under 2 : 1 binary CH/N mixed-gas conditions bordering on the loss of selectivity. For 6FDA-bisAPAF, both permeabilities decreased in the mixed-gas case, but more for N than for CH. For TR-PBO, the permeability of the faster N decreased while the permeability of the slower CH increased under mixed-gas conditions. This confirms that single-gas simulations are not sufficient for the prediction of the actual mixed-gas permselectivity behaviour in such polymers.

摘要

通过芳族聚酰亚胺前体的热重排(TR)形成的具有聚苯并恶唑(PBO)结构的高性能聚合物已被开发用于气体分离应用。本工作使用分子动力学(MD)模拟比较了6FDA-双APAF聚酰亚胺前体及其TR-PBO衍生物中N和CH的传输情况。该建模通过一种特定算法将6FDA-双APAF原子模型转变为其相应的TR-PBO结构,紧密模仿了实验方法。发现前体聚合物和TR聚合物的密度与空隙空间与实验数据吻合良好。采用迭代技术在高达并超过65 bar的一系列进料压力下,获得了两种聚合物在338.5 K时N和CH的单气体吸附等温线。系统地发现CH比N更易溶。两种基质中的溶解度相当相似,TR-PBO中的溶解度略高,因为其具有更大比例的有效体积。体积膨胀分析证实TR-PBO对增塑具有更高的抗性。然后在338.5 K和对应于天然气处理条件的约65 bar压力下,在两种基质中进行了扩展的单气体N和CH模拟以及2∶1二元CH/N混合气体模拟。混合气体吸附采用上述迭代方法的改进版本进行建模,该方法固定压力并迭代至每种渗透剂分子数收敛。使用轨迹扩展动力学蒙特卡罗(TEKMC)程序估算气体扩散系数。如实验所发现的,在TR聚合物中观察到显著更高的扩散率和渗透率,这导致TR-PBO的理想N/CH渗透选择性(约2.6)与其6FDA-双APAF前体(约3.8)相比略低。然而,在2∶1二元CH/N混合气体条件下,两种模型都显示出N/CH分离效率降低,几乎失去选择性。对于6FDA-双APAF,在混合气体情况下两种渗透率均降低,但N的降低幅度大于CH。对于TR-PBO,在混合气体条件下,较快的N的渗透率降低而较慢的CH的渗透率增加。这证实了单气体模拟不足以预测此类聚合物中实际的混合气体渗透选择性行为。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验