Suppr超能文献

评估泰国曼谷市城市下游湄南河的微塑料污染。

Assessment of microplastic contamination in the urban lower Chao Phraya River of Bangkok city, Thailand.

机构信息

Department of Civil and Environmental Engineering, Faculty of Engineering, Mahidol University, Nakhonpathom 73170, Thailand E-mail:

Graduate School of Global Environmental Studies, Kyoto University, Yoshida, Sakyo-Ku, Kyoto, 606-8501, Japan.

出版信息

J Water Health. 2022 Aug;20(8):1243-1254. doi: 10.2166/wh.2022.130.

Abstract

Rivers are one of the major pathways for the transportation of microplastics (MPs) from land-based sources to the ocean. However, there are only a few studies on MPs in freshwater environments, particularly in Asian countries. In this study, MP contamination in the Chao Phraya River in selected locations distributed throughout Bangkok, Thailand was investigated. MPs were collected using a Manta net with a mesh size of 335 μm. After digestion and distinction based on density, MPs were observed using a stereomicroscope, and polymer types were identified using Fourier Transform Infrared Spectroscopy. MP concentrations detected in the five sampling locations of the river water from upstream to downstream were 11, 35, 40, 15, and 4 particles/m, with an average concentration of 21±16 particles/m. Most MPs were identified as either fragments or sheets/films. Polypropylene was the dominant polymer type. The number of MPs increases as their size decreases. Potential sources of MPs may include the degradation of single-use plastic products, especially containers and plastic packaging. MP concentrations and characteristics varied for different locations, indicating different sources and pathways of MPs in urban contexts. Further investigation on the different pathways of the transportation of MPs to river water from land-based sources is required.

摘要

河流是陆地源向海洋输送微塑料 (MPs) 的主要途径之一。然而,目前关于淡水环境中 MPs 的研究较少,特别是在亚洲国家。本研究调查了泰国曼谷市分布在不同位置的昭拍耶河中的 MPs 污染情况。使用网孔尺寸为 335μm 的曼塔网收集 MPs。经过消解和密度区分后,使用立体显微镜观察 MPs,并使用傅里叶变换红外光谱法鉴定聚合物类型。在河流从上游到下游的五个采样点检测到的 MP 浓度分别为 11、35、40、15 和 4 个/立方米,平均浓度为 21±16 个/立方米。大多数 MPs 被鉴定为碎片或片/膜。聚丙烯是主要的聚合物类型。MP 的数量随着其尺寸的减小而增加。MP 的潜在来源可能包括一次性塑料产品(尤其是容器和塑料包装)的降解。不同地点的 MPs 浓度和特征有所不同,表明城市环境中 MPs 的来源和途径不同。需要进一步研究从陆地源向河水输送 MPs 的不同途径。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验