Kinematic Analysis of Sequential Partial-Midfoot Arthrodesis in Simulated Gait Cadaver Model.

BACKGROUND

Primary tarsometatarsal (TMT) arthrodesis is gaining popularity in the surgical treatment of Lisfranc injuries. However, few studies have evaluated biomechanical effects of TMT arthrodesis. The purpose of this study was to compare the kinematics of joints adjacent to the midfoot during simulations of stance before and after sequential arthrodesis of the first, second, and third TMT joints.

METHODS

Ten midtibia cadaveric specimens were loaded on a 6-degree-of-freedom robotic gait simulator. Motion capture cameras were used to collect joint kinematics throughout simulations of the stance phase. Simulations were performed for the intact and sequential arthrodesis conditions of the first, second, and third TMT joints. The sagittal, coronal, and transverse plane rotational kinematics of the intact condition were compared to kinematics after each sequential arthrodesis condition.

RESULTS

Sequential arthrodesis of the first and second TMT joints had no significant effect on ankle, subtalar, talonavicular, and first metatarsophalangeal joint motion during simulated stance when compared to the intact condition. In contrast, inclusion of the third TMT joint into the sequential arthrodesis significantly increased subtalar inversion ( = .032) in late stance and increased range of motion values in the ankle and subtalar joints by 2.1 degrees ( = .009) and 2.8 degrees ( = .014), respectively.

CONCLUSION

Sequential primary arthrodesis induced changes to ankle and adjacent joint kinematics during stance phase simulations, although not until the third TMT joint was included into the primary arthrodesis. The significant changes to kinematics due to arthrodesis of the first, second, and third TMT joints were small.

CLINICAL RELEVANCE

The minimal changes in sagittal, coronal, and transverse plane rotational kinematics support the positive clinical outcomes reported in the literature for primary partial arthrodesis of Lisfranc injuries. The inclusion of the third TMT joint should be done judiciously.