STATEMENT OF PROBLEM

Optimal implant positioning is essential to achieving predictable results. Computer-guided surgery has been reported to be an accurate technique for implant placement in healed sites, but the accuracy of guided techniques for immediate implant placement into fresh sockets is still unclear.

PURPOSE

The purpose of this experimental randomized split-mouth study in pig jaws was to determine the accuracy of partially and fully guided surgical techniques for immediate implant placement into fresh sockets and to compare 2 different methods of implant position deviations analysis.

MATERIAL AND METHODS

Twenty implants were installed in 10 pig jaws using 2 different techniques: partially guided (n=10) and fully guided (n=10). Cone beam computed tomography and digital scanning were performed before and after the surgical procedure to plan the virtual implant position and fabricate the surgical guide, as well as to determine implant position deviations. Two methods were used to evaluate implant deviations: tomographic and digital scanning. The Shapiro-Wilk test of normality was used. Deviation comparisons were carried out by using paired t tests (α=.05), and intraclass correlation coefficient (ICC) was computed to assess the agreement between the 2 methods of implant deviation analysis.

RESULTS

In the tomographic analysis, the partially guided technique resulted in significantly higher global apical and lateral coronal deviations (2.25 ±0.59 mm; 0.96 ±0.55 mm) than fully guided (1.52 ±0.89 mm; 0.75 ±0.52 mm) (P<.01 and P<.05, respectively). The analysis performed using digital scanning showed significantly higher angular, global apical, and lateral apical deviations in the partially guided (6 ±3.28 degrees; 2.49 ±1.03 mm; 2.16 ±1.07 mm) technique than in the fully guided (3.32 ±1.84 degrees; 1.5 ±0.58 mm; 0.98 ±0.67 mm) (P<.05). An ICC of 0.522 between the 2 methods of implant deviation analysis was obtained.

CONCLUSIONS

The partially guided technique was less accurate than the fully guided technique for immediate implant placement into fresh sockets. A moderate concordance was observed between cone beam computed tomography and digital scanning analyses, suggesting that more studies are required to validate and to define the most reliable method of measuring implant deviation.