Combination of Zinc Oxide Photocatalysis with Membrane Filtration for Surface Water Disinfection.

Increase water usage has led to its deterioration. Pollutants are easily found in the aquatic environment and treatment techniques must keep improving to meet the current needs and future demands. Membranes are attractive for water treatment, but limitations like fouling and the highly concentrate produced affect their performance. Combining membrane filtration with photocatalysis provides the opportunity to integrate a self-cleaning step during membrane filtration. In this work, we studied two simple and efficient approaches to combine membrane filtration with zinc oxide nanoparticles (using the catalyst in suspension and immobilized) activated by light emitting diodes (LED) emitting light at 365 nm. Both systems were used to test the disinfection efficiency in real surface water, compared in terms of catalyst concentration in the permeate stream (below the limit of detection) and its recovery after filtration (higher that 74%). The system's capability to retain and inactivate target bacteria (total coliforms and ) in the retentate stream was tested with samples of real surface water. The results obtained show that both configurations led to an improved performance in comparison to the membrane treatment alone with a higher retention of the bacteria (not detected in the permeate samples) and higher treatment of the retentate. For the modified membranes, different catalyst concentrations and thermal treatments were tested. The performance of all the processes was evaluated in terms of the level of treatment achieved and the permeate flux. All the modified membranes showed an efficient retention of the target bacteria from surface water, with higher performances than the unmodified membrane (96.2% for total coliforms and 94.9% for ). Remarkable retention and treatment of the retentate was achieved using a membrane modified with a catalyst load of 125 mg subject during two hours to a thermal treatment of 300 °C. This modification has a performance comparable to the system with the same catalyst load in suspension. During operation, the permeate flux reduction is lower with the modified membranes which could lead to longer operation times without the need of further cleaning or replacement. The combined system, ceramic membranes modified with zinc oxide and UV-A LEDs proved to be effective to retain and disinfect water quality indicator bacteria present in real surface water matrices.