Welch A J, Bradley A B, Torres J H, Motamedi M, Ghidoni J J, Pearce J A, Hussein H, O'Rourke R A
Department of Electrical and Computer Engineering, University of Texas at Austin 78712.
Circulation. 1987 Dec;76(6):1353-63. doi: 10.1161/01.cir.76.6.1353.
The metal-tipped optical fiber or "laser probe" has been extensively studied in animal preparations in vivo and in human clinical trials of revascularization. The aim of this study was to evaluate the thermal characteristics of laser probe tissue ablation and to contrast the vascular tissue response to exposure to the laser probe and bare optical fiber. A 2 mm laser probe was heated with up to 4 W of argon-ion laser irradiation and applied to six postmortem strips of human nonatherosclerotic aorta as well as to five atherosclerotic aortic specimens. Surface temperature maps of the laser probe and of the vascular tissue in air were obtained via 8 to 12 micron thermographic imaging. Laser probe temperature was additionally monitored via thermocouples. Two strips each of normal and diseased aorta were irradiated directly with the bare optical fiber. Thus a total of 43 laser probe application sites and 19 bare fiberoptic laser irradiation sites on a total of 15 aortic strips were analyzed both thermographically and histologically. Based on measured temperature rises and histologic findings, the following observations were made: (1) The laser probe heats initially at its tip and attains a uniform surface temperature distribution within 5 sec. The steady-state temperature attained by the probe is inversely related to the thermal conductivity of the surrounding media. In all media studied, probe temperature increases linearly with applied laser energy. (2) Tissue ablation starts at temperatures greater than 100 degrees C, and ablation temperatures typically exceed 180 degrees C. Adventitial temperatures during laser probe application may reach 70 degrees C. Tissue ablation is enhanced both by greater laser energy deposition in the probe and by higher force at which the probe is applied to tissue. (3) Ablation of fibrofatty atheromata is more extensive than of nonatherosclerotic aortic tissue. This may be due to the lower thermal conductivity of atheromatous tissue. (4) In contrast to direct argon-ion laser ablation of aortic tissue, laser probe-mediated ablation occurs in a controlled fashion, is not associated with extensive subintimal dissections, and allows uniform conduction of heat to tissue as reflected by essentially "isothermal" injury lines.
金属头光纤或“激光探头”已在动物体内实验以及血管再生的人体临床试验中得到广泛研究。本研究的目的是评估激光探头组织消融的热特性,并对比血管组织对激光探头和裸光纤照射的反应。使用高达4瓦的氩离子激光照射加热一个2毫米的激光探头,并将其应用于6条人类非动脉粥样硬化主动脉的死后标本条以及5个动脉粥样硬化主动脉标本。通过8至12微米的热成像获得激光探头和空气中血管组织的表面温度图。另外通过热电偶监测激光探头的温度。分别用裸光纤直接照射两条正常主动脉和病变主动脉标本条。因此,总共对15条主动脉标本条上的43个激光探头应用部位和19个裸光纤激光照射部位进行了热成像和组织学分析。基于测量的温度升高和组织学结果,得出以下观察结果:(1)激光探头最初在其尖端加热,并在5秒内达到均匀的表面温度分布。探头达到的稳态温度与周围介质的热导率成反比。在所有研究的介质中,探头温度随施加的激光能量呈线性增加。(2)组织消融在温度高于100摄氏度时开始,消融温度通常超过180摄氏度。激光探头应用期间外膜温度可能达到70摄氏度。更大的激光能量在探头中的沉积以及探头施加到组织上的更大压力都会增强组织消融。(3)纤维脂肪性动脉粥样硬化斑块的消融比非动脉粥样硬化主动脉组织更广泛。这可能是由于动脉粥样硬化组织的热导率较低。(4)与主动脉组织的直接氩离子激光消融相比,激光探头介导的消融以可控方式发生,与广泛的内膜下剥离无关,并且如基本“等温”的损伤线所示,允许热量均匀地传导至组织。