Department of Chemistry, University of Oslo, Sem Sælandsvei 26, 0371 Oslo, Norway.
Langmuir. 2023 Mar 21;39(11):3914-3933. doi: 10.1021/acs.langmuir.2c03207. Epub 2023 Mar 9.
Understanding the pathways of solubilization of lipid membranes is of high importance for their use in biotechnology and industrial applications. Although lipid vesicle solubilization by classical detergents has been widely investigated, there are few systematic structural and kinetic studies where different detergents are compared under varying conditions. This study used small-angle X-ray scattering to determine the structures of lipid/detergent aggregates at different ratios and temperatures and studied the solubilization in time using the stopped-flow technique. Membranes composed of either of two zwitterionic lipids, DMPC or DPPC, and their interactions with three different detergents, sodium dodecyl sulfate (SDS), -dodecyl-beta-maltoside (DDM), and Triton X-100 (TX-100), were tested. The detergent TX-100 can cause the formation of collapsed vesicles with a rippled bilayer structure that is highly resistant to TX-100 insertion at low temperatures, while at higher temperatures, it partitions and leads to the restructuring of vesicles. DDM also causes this restructuring into multilamellar structures at subsolubilizing concentrations. In contrast, partitioning of SDS does not alter the vesicle structure below the saturation limit. Solubilization is more efficient in the gel phase for TX-100 but only if the cohesive energy of the bilayer does not prevent sufficient partitioning of the detergent. DDM and SDS show less temperature dependence compared to TX-100. Kinetic measurements reveal that solubilization of DPPC largely occurs through a slow extraction of lipids, whereas DMPC solubilization is dominated by fast and burst-like solubilization of the vesicles. The final structures obtained seem to preferentially be discoidal micelles where the detergent can distribute in excess along the rim of the disc, although we do observe the formation of worm- and rodlike micelles in the case of solubilization of DDM. Our results are in line with the suggested theory that bilayer rigidity is the main factor influencing which aggregate is formed.
理解脂质膜的增溶途径对于它们在生物技术和工业应用中的使用非常重要。尽管经典去污剂对脂质囊泡的增溶作用已经得到了广泛的研究,但在不同条件下比较不同去污剂的系统结构和动力学研究很少。本研究使用小角 X 射线散射来确定不同比例和温度下的脂质/去污剂聚集体的结构,并使用停流技术研究随时间的增溶作用。使用两种两性离子脂质,DMPC 或 DPPC,以及三种不同的去污剂,十二烷基硫酸钠(SDS)、-十二烷基-β-麦芽糖苷(DDM)和 Triton X-100(TX-100),来测试膜的相互作用。去污剂 TX-100 可以导致形成具有波纹双层结构的塌陷囊泡,这种结构在低温下对 TX-100 的插入具有高度抵抗力,而在较高温度下,它会进行分区并导致囊泡的重构。DDM 也会导致在亚增溶浓度下形成多层结构。相比之下,SDS 的分区不会改变低于饱和极限的囊泡结构。对于 TX-100,凝胶相中的增溶效率更高,但前提是双层的内聚能量不会阻止去污剂的充分分区。与 TX-100 相比,DDM 和 SDS 的温度依赖性较小。动力学测量表明,DPPC 的增溶主要通过缓慢提取脂质发生,而 DMPC 的增溶则主要由快速和爆发式的囊泡增溶主导。最终获得的结构似乎更倾向于盘状胶束,其中去污剂可以沿着盘的边缘过量分布,尽管我们确实观察到在 DDM 的增溶过程中形成了蠕虫状和棒状胶束。我们的结果与建议的理论一致,即双层刚性是影响形成哪种聚集体的主要因素。